This is information on a product in full production. For further information contact your local STMicroelectronics sales
office.
September 2013 Doc ID 023626 Rev. 2 1/4
1
SPC560B64A100S
SPC560BADPT144S, SPC560BADPT176S
SPC560Bxx microcontroller family evaluation board
Data brief
−
production data
Features
■
SPC560Bxx modular evaluation system
■
On/off power switch with LED indicators
■
Board power supply: 12 VDC external supply
voltage
■
Onboard STMicroelectronics
®
L9758 voltage
regulator with three simultaneous output at
1.2 V, 3.3 V and 5 V
■
Possibility to configure onboard peripherals to
operate at 5 V or 3.3 V logic levels, depending
on target
■
Up to two CAN channels with jumper enable
(a)
– One CAN channel with High-Speed
transceiver and DB9 male connector
– One CAN channel with Low-Speed Fault
Tolerant and High-Speed transceiver
(selectable with jumpers) and DB9 male
connector
■
Up to two LIN channels with jumper enable
(a)
– One channel with transceiver and pin
header connector populated
– One channel with footprints only
■
One SCI channel with jumper enables,
transceiver and DB9 female connector
■
Four user push buttons with jumper enable and
polarity selection
■
Four user LED’s with jumper enables
■
One potentiometer for analog voltage input
■
Pin array for accessing all I/O signals
■
Expansion connectors for accessing all I/O
signals
■
Prototyping area with 0.1” spacing and SOIC
footprint
■
Specifications:
– Board size 110 mm x 75 mm
– 12 VDC Center Positive power supply with
2.5/5.5 mm barrel connector
Description
The SPC560B64A100S, SPC560BADPT144S
and SPC560BADPT176S are evaluation systems
supporting the STMicroelectronics
®
SPC560Bxx
family of automotive microprocessors. The
complete system consists of a SPC56XXMB
motherboard and a mini module which plugs
directly into the motherboard. Different mini
modules are available for evaluating the whole
family of devices in all supported packages.
The evaluation systems allow full access to the
CPU, to all of the CPU’s I/O signals and to the
motherboard’s peripherals (such as CAN, SCI
and LIN).
The mini modules itself can be used as a stand-
alone unit when access to the I/O pins or
peripherals is not needed.
a. See devices datasheet for detailed information.
www.st.com
