PACKING
0.19Kg;72pcs/15.6Kg/1.35CUFT
DC VOLTAGE
SPECIFICATION
MODEL
OUTPUT
RATED CURRENT
CURRENT RANGE
RATED POWER
RIPPLE & NOISE (max.) Note.2
VOLTAGE TOLERANCE Note.3
LINE REGULATION
LOAD REGULATION
VOLTAGE RANGE
SETUP, RISE, HOLD UP TIME
EFFICIENCY(Typ.)
DC CURRENT(Typ.)
OVER LOAD
OVER VOLTAGE
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
DIMENSION
INPUT
PROTECTION
ENVIRONMENT
SAFETY &
EMC
OTHERS
NOTE
12V
2.5A
0 ~ 2.5A
30W
120mVp-p
1000ms, 50ms, ----/12VDC/24VDC at full load; 1500ms,50ms,----48VDC at full load
A: 9.2 ~18VDC (12VDC) B:18 ~ 36VDC (24VDC) C:36~72VDC(48VDC)
74%
3.5A/12VDC 2.5A/24VDC 1.2A/48VDC
105% -160% rated output power
Protection type :shut down, Re-power on after fault condition is removed
5.75 ~ 6.75V/10%load
20 ~ 95% RH non-condensing
10 ~ 500Hz, 2G 10min./1cycle, Period for 60min.each along X, Y, Z axes
127*76*30mm (L*W*H)
File Name:PSD-45 SPEC 2018-01-12
2:1 wide input range
Protections:Short circuit/Over load /Over voltage/Polarity
Cooling by free air convection
Built-in EMI filter, low ripple noise
100% full load burn-in test
Fixed switching frequency at KHZ
96
Low cost
High reliability
2 year warranty
1.All parameters NOT specially mentioned are measured at normal input,rated load and 25 of ambient temperature.℃
2.Ripple & noise are measued at 20 MHz of bandwidth by using a 12inch twisted pair-wire termined with a 0.1uf & 47uf capacitor.
3.Tolerance:includes set up tolerance,line regulation and load regulation.
4.The interval of turning ON and OFF the power supply continuously is 2 seconds.
5.The ambient temperature derating of 3.5 /1000m with fanless models and of 5 /1000m with fan models for operating altitude ℃℃
higher than 2000m(6500ft).
PSD-45C-12
5V
6A
0 ~ 6A
30W
100mVp-p
24V
1.25A
0 ~ 1.25A
30W
150mVp-p
78%
79%
13.8~ 16.2V/10%load
27.6 ~ 32.4V/10%load
EMI CONDUCTION&RADIATION
Compliance to EN55032(CISPR32) CLASS B, EAC TP TC 020
PSD-45A-24
PSD-45A-12
PSD-45B-12
PSD-45B-24
PSD-45C-24
PSD-45C-05
PSD-45B-05
PSD-45A-05
77%
80%
82%
83%
85%
86%
■ Features :
EMS IMMUNITY
Compliance to EN61000-4-2, 3, 4, 6, 8 EN55024, EN61000-6-1 Light industry level, criteria A, EAC TP TC 020
VOLTAGE ADJ RANGE
4.5 ~ 5.5V
10.8 ~13.2V
21.6 ~ 26.4V
± 2.0%
± 0.5%
± 0.5%
± 2.0%
± 1.0%
± 1.0%
± 2.0%
± 1.0%
± 1.0%
I/P-O/P:1.5KVAC I/P-FG:2.0KVAC O/P-FG:0.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC / 25 / 70% RH℃
-10 ~ +60 (Refer to output load derating curve),20~90%RH non-condensing℃
-20 ~ +85 , 10 ~ 95% RH℃
±℃ ℃0.05%/ (0 ~ 50 )
PSD-45series
45W DC-DC Single Output Switching Power Supply
Protection type : Hiccup mode, recovery automatically after fault condition is removed
5V
9A
0 ~ 9A
45W
5V
9A
0 ~ 9A
45W
12V
3.75A
0 ~ 3.75A
45W
12V
3.75A
0 ~ 3.75A
45W
24V
1.875A
0 ~ 1.875A
45W
24V
1.875A
0 ~ 1.875A
45W
SAFETY STANDARDS
EAC TP TC 004 approved, EN60950-1 CB approved by TUV
MTBF
329.3Khrs min. MIL-HDBK-217F (25 )℃
