7
Package Characteristics
*The Input-Output Momentary Withstand Voltage is a dielectric voltage rating that should not be interpreted as an
input-output continuous voltage rating.
Parameter Symbol Min. Typ. Max. Units Test Conditions Fig. Note
Input-Output Momentary
Withstand Voltage*
V
ISO
3750 V
RMS
RH ≤ 50%, t = 1 min;
T
A
= 25°C
6, 7
Input-Output Resistance R
I-O
10
14
V
I-O
= 500 V
DC
6
Input-Output Capacitance C
I-O
0.6 pF f = 1 MHz; V
I-O
= 0 V
DC
6
Notes:
1. Derate linearly above 85°C free-air temperature at a rate of 0.25mA/°C.
2. Derate linearly above 85°C free-air temperature at a rate of 0.30mA/°C.
3. Derate linearly above 85°C free-air temperature at a rate of 0.375mW/°C.
4. Derate linearly above 85°C free-air temperature at a rate of 1.875mW/°C.
5. Current Transfer Ratio in percent is de ned as the ratio of output collector current, I
O
, to the forward LED input current, I
F
, times 100.
6. Device considered a two terminal device: pins 1 and 3 shorted together, and pins 4,5,and 6 shorted together.
7. In accordance with UL 1577, each optocoupler is proof tested by applying an insulation test voltage > 4800V
RMS
for 1 second.
8. This is in a 4-pin con guration where the V
CC
and V
O
pin are shorted together.
9. Common transient immunity in a Logic High level is the maximum tolerable (positive) dV
CM
/dt on the rising edge of the common mode pulse, V
CM
,
to assure that the ouput will remain in a Logic High state (i.e., Vo > 2.0V). Common mode transient immunity in a Logic Low level is the maximum
tolerable (negative) dV
CM
/dt on the falling edge of the common mode pulse signal, V
CM
to assure that the output will remain in a Logic Low state
(i.e., Vo < 0.8V).
