LSM0603472V | Page 6 of 8
07/18 Rev1
A soldering iron of less them 20W is recommended to be used in Hand Soldering. Please keep the
temperature of the soldering iron under 300° C while soldering. Each terminal of the LED is to go for
less than 3 seconds and for one time only.
Be careful because the damage to the product is often started at the time of the hand soldering.
• Hand Soldering
Use the conditions shown in the figure below for PB-Free Reflow Soldering.
• Reflow Soldering
• Reflow soldering should not be done more than two times.
• Stress on the LEDs should be avoided during heating in soldering process.
• After soldering, do not handle the product before its temperature drops down to room temperature.
Your first call for illuminated components
vcclite.com 1.800.522.5546
Recommended Reflow Soldering Profile