Obsolete Product(s) - Obsolete Product(s)
TSH10
4/5
EVALUATION CIRCUIT
PRINTED CIRCUIT LAYOUT
As for any high frequency device, a few rules must
be observed when designing the PCB to get the
best performances from this high speed op amp.
From the most to the least important points :
❑ Each power supply lead has to be by-
passed to ground with a 10nF ceramic ca-
pacitor very close to the device and a 10µF
tantalum capacitor.
❑ To provide low inductance and low resist-
ance common return, use a ground plane
or common point return for power and sig-
nal.
❑ All leads must be wide and as short as pos-
sible especially for op amp inputs. This is in
order to decrease parasitic capacitance
and inductance.
❑ Use small resistor values to decrease time
constant with parasitic capacitance. Be
aware on TSH10 device of the Iio error and
input noise currents with high feedback re-
sistor values.
❑ Choose component sizes as small as pos-
sible (SMD).
❑ On output, decrease capacitor load so as
to avoid circuit stability being degraded
which may cause oscillation. You can also
add a serial resistor in order to minimise its
influence.
❑ One can add in parallel with feedback re-
sistor a few pF ceramic capacitor C
F
adjust-
ed to optimize the settling time.
Input
1k
W
10nF
10mF
C
F
-5V
+5V
10nF
10
m
F
Output
50
W
1k
W
50
W
Obsolete Product(s) - Obsolete Product(s)
