Copyright © Murata Manufacturing Co., Ltd. All rights reserved. 2015
PX1004 (R) 2/2/17 Page 1 of 5
www.murata.com
Electrical Characteristics
Characteristic Sym Notes Min Typ Max Units
Nominal Center Frequency
f
C
1
82.200
MHz
Passband Insertion Loss at fc
IL
34.0dB
3 dB Passband
BW
3
1, 2
±15 ±25 kHz
Amplitude Ripple over fc ±15 kHz
1.0
dB
P-P
Group Delay Variation over fc ±10 kHz
GDV 2.5 6.0
µs
P-P
Third-Order Intermod. for -20 dBm tones at fc ±60 & 120 kHz
-95
dBm
Rejection fc ±60 kHz
1, 2, 3
10 16
dBfc -880 kHz to fc -940 kHz 65 68
Ultimate 65
Operating Temperature Range
T
A
1-20
+70
°C
Impedance Matching to 50 unbalanced External L-C
Case Style SM13365-12 13.3 X 6.5 mm Nominal Footprint
Lid Symbolization (YY=year, WW=week) See note 4 RFM PX1004 YYWW
SM13365-12
• Designed for TDMA IS-54 / CDPD IF Applications
• Low Insertion Loss
• Excellent Selectivity
• Hermetic 13.3 X 6.5 mm Surface-Mount Case
• Unbalanced Input and Output
• Complies with Directive 2002/95/EC (RoHS)
Absolute Maximum Ratings
Rating Value Units
Maximum Incident Power in Passband +10 dBm
Max. DC voltage between any 2 terminals 30 VDC
Storage Temperature Range -40 to +85 °C
Suitable for lead-free soldering - Max Soldering Profile 260°C for 30 s
82.2 MHz
SAW Filter
PX1004
1. Unless noted otherwise, all specifications apply over the operating temperature
range with filter soldered to the specified demonstration board with impedance
matching to 50 and measured with 50 network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the
nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the
passband. Rejection in final user application is dependent on PCB layout and
external impedance matching design. See Application Note No. 42 for details.
4. "LRIP" or "L" after the part number indicates "low rate initial production" and
"ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are subject
to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design.
However, impedances and impedance matching may vary between Port 1 and
Port 2, so that the filter must always be installed in one direction per the circuit
design.
7. US and international patents may apply.
8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered
trademarks of Murata Manufacturing Co., Ltd.
Caution: Electrostatic Sensitive Device. Observe precautions for handling.
NOTES:
Electrical Connections
Connection Terminals
Port 1Hot 2
Port 1 Gnd Return 3
Port 2 Hot 8
Port 2 Gnd Return 9
Case Ground All Others
Pb
