LIGHTLINE
AC/DC-Converter
with 5 year Warranty
RACD60
60 Watt PFC
Single Output
● 60W Class II AC-DC LED Power Supply
● Constant Current Operation
● Power Factor Corrected
● Universal Input Voltage Range
● User Adjustable Current Limit (/OF)
● Thermal Feedback Dimming (/TOF)
● Waterproof Enclosure (/IP67)
● cUL/UL8750 Certified, CE Marked
● Class 2 Power Unit UL1310
● High Efficiency
● Long 5 Year Warranty
Features
LED DRIVER
Selection Guide
Part Output Output Factory Set Efficiency Output
Number Voltage Range Current Range Current (230VAC) Power
(min - max)** (min - max) Limit Typ. Range
RACD60-700* 38 - 54V 700 - 1100mA 0.7A 89% 27-60W
RACD60-1050* 38 - 54V 700 - 1100mA 1.0A 89% 27-60W
RACD60-1400* 21 - 28V 1400 - 2140mA 1.4A 89% 30-60W
RACD60-2100* 21 - 28V 1400 - 2140mA 2.1A 89% 30-60W
RACD60-2400* 17 - 24V 2150 - 2500mA 2.4A 87% 30-60W
RACD60-4200* 11 - 13.5V 3570 - 4200mA 4.2A 85% 40-60W
* use suffix /OF for open frame version (standard) - output current limit adjustable with on-board trimmer
* use suffix /TOF for open frame version with thermal feedback - output current limit externally adjustable.
* use suffix /IP67 for waterproof potted version - fixed output currents only
** adjustable output current range at potentiometer (only /OF types)
Input Voltage Range All Versions 90-264VAC
Rated Power 60 Watts max.
Input Frequency Range All Versions 50/60 Hz
Power Factor Correction Full Load, 115VAC/230VAC > 0.9
THD Full Load, 115VAC 17% max.
Full Load, 230VAC 20% max.
Input Current (full load) 115VAC/230VAC 0.8A / 0.4A max.
Inrush Current (cold start) 115VAC/230VAC 25A / 50A max.
Leakage Current 230VAC/63Hz <0.7mA max.
Input Fuse Built-in 3.15A Slow Blow
Output Current Accuracy Full load ±5%
Output Current Adjust Preset Potentiometer (/OF) 75% to 100% approx.
External Voltage (/TOF)
Line Voltage Regulation LL to HL at Full Load ±4% typ.
Load Voltage Regulation 60% to 100% Load ±5% typ.
Minimum Load Current see table
Operating Frequency All Versions 65kHz typ.
continued on next Page
Description
Specifications
(typical at 25°C and after warm up time unless otherwise specified )
The RACD60 is a compact universal input voltage 60W constant current power module suitable for driving high power LEDs.
The RACD60 series have active power factor correction, universal input voltage range and are fully protected against
output short circuit, overload and over-temperature. Three versions are available: a low cost open-frame with either internal
(/OF) or external user-adjustable current limit (/TOF), and a sealed IP67 potted version (/IP67) with factory set output
currents for outdoor or high humidity applications. The LED driver is a class II power supply with CSA, UL and CE
certifications and comes with a five year warranty.
UL 8750 Certified
cUL 8750 Certified*
EN 61347 Certified
E340696
ordering examples:
RACD60-700/OF= open frame, adustable current limit preset to 700mA.
RACD60-1050/TOF=open frame,1050mA, adjustable 700-1050mA with ext. voltage or PWM signal.
RACD60-1400/IP67 = enclosed IP67 waterproof, non-adjustable 1400mA output.
Note: all currents within range are available - use RACD60-xxxx/IP67 where xxxx is the desired fixed current
e.g. RACD60-900/IP67 = enclosed IP67 waterproof, non-adjustable 900mA output.
* except 700mA/1100mA Versions
RoHS
2011/65/EU
6/6
Note:
All LED Drivers may not be used without a
load. They must be switched on the primary
side only. Noncompliance may damage the
LED or reduce its lifetime.
Refer to Application Notes
L-50 www.recom-power.comREV: 1/2016
NOT RECOMMENDED
FOR
NEW DESIGNS
