V
DIV1
= 2.4V, Z
L
= 50Ω,
MAX2424/MAX2426
900MHz Image-Reject Receiver
with Transmit Mixer
4 _______________________________________________________________________________________
AC ELECTRICAL CHARACTERISTICS (continued)
(MAX2424/MAX2426 EV kit, V
CC
= +3.3V, f
RXIN
= 915MHz, P
RXIN
= -35dBm, V
TXIN
= V
TXIN
= 2.3V (DC bias), V
TXIN
= 250mVp-p,
f
TXIN
= 1MHz, V
LNAGAIN
= 2V, V
VCOON
= 2.4V, RXON = TXON = MOD = DIV1 = PREGND = GND, T
A
= +25°C, unless otherwise noted.)
PARAMETER MIN TYP MAX UNITS
Oscillator Phase Noise
Oscillator Frequency Range 800 1100 MHz
82
dBc/Hz
(Note 6)
CONDITIONS
Note 6: Guaranteed by design and characterization.
Note 7: Image rejection typically falls to 30dBc at the frequency extremes.
Note 8: Refer to the Typical Operating Characteristics for a plot showing Receiver Gain vs. LNAGAIN Voltage, Input IP3 vs.
LNAGAIN Voltage, and Noise Figure vs. LNAGAIN Voltage.
Note 9: Two tones at P
RXIN
= -45dBm each, f1 = 915.0MHz and f2 = 915.2MHz.
Note 10: Time delay from V
RXON
= 0.45V to V
RXON
= 2.4V transition to the time the output envelope reaches 90% of its final value.
Note 11: Output power typically falls to -10dBm at the frequency extremes.
Note 12: Two tones at V
TXIN
= 125mVp-p, f1 = 1.0MHz, and f2 = 1.2MHz.
Note 13: Time delay from V
TXON
= 0.45V to V
TXON
= 2.4V transition to the time the output envelope reaches 90% of its final value.
Note 14: Using tank components L3 = 5.0nH (Coilcraft A02T), C2 = C3 = C26 = 3.3pF, R6 = R7 = 10Ω.
Note 15: This approximates a typical application in which TXOUT is followed by an external PA and a T/R switch with finite isolation.
Note 16: Relative to the rising edge of PREOUT.
Prescaler Output Level
500 mVp-p
-11 -8
Required Modulus Setup Time
(Notes 6, 16)
10 ns
Z
L
= 100kΩ
| |
10pF
÷ 64/65 mode
Required Modulus Hold Time
(Notes 6, 16)
0 ns
÷ 64/65 mode
Oscillator Buffer Output Level
(Notes 6, 14)
-12
dBm
V
DIV1
= 2.4V,
Z
L
= 50Ω
10kHz offset (Note 14)
72
Standby to TX or Standby to RX
35
Oscillator Pulling
8
kHz
110
RX to TX with P
RXIN
=- 45dBm (RX mode)
to P
RXIN
= 0dBm (TX mode) (Note 15)
MAX2424
MAX2426
MAX2424
MAX2426
MAX2424
MAX2426
70
T
A
= +25°C
T
A
= -40°C to +85°C
OSCILLATOR AND PRESCALER