SEN0129

AnalogGasSensor(MQ4)(SKU:SEN0129)
Contents
1 Introduction
1.1 Specification
2 Pin Definition
3 Potentiometer
3.1 Connection Diagram
3.2 Sample Code
Introduction
The MQ4 is used in gas leakage detecting equipment in consumer and industry markets,this sensor
is suitable for detecting CH4,Natural gas, LNG, avoid exposure to alcohol, cooking fumes, and
cigarette smoke. The sensitivity can be adjusted by the potentiometer.
Specification
Power supply needs: 5V
Interface type: Analog
Pin Definition: 1-Output 2-GND 3-VCC
High sensitivity to CH4£¬Natural gas
Small sensitivity to alcohol, smoke
Fast response
Stable and long life
Simple drive circuit
Size: 40x20mm
PinDefinition
1. Signal Output
2. GND
3. Power
Analog Sensor Pin Definition
Potentiometer
Potentiometer is used to calibrate the readings from this sensor as stated on the datasheet:
SENSITVITY ADJUSTMENT
Resistance value of MQ-4 is difference to various kinds and various concentration gases. So,When
using this components, sensitivity adjustment is very necessary. we recommend that you calibrate
the detector for 5000ppm of CH4 concentration in air and use value of Load resistance ( RL) about
20K(10K to 47K). When accurately measuring, the proper alarm point for the gas detector
should be determined after considering the temperature and humidity influence.
ConnectionDiagram
Analog sensor connection diagram
SampleCode
///Arduino Sample Code
void setup()
{
Serial.begin(9600); //Set serial baud rate to 9600 bps
}
void loop()
{
int val;
val=analogRead(0);Read Gas value from analog 0
Serial.println(val,DEC);//Print the value to serial port
delay(100);
Powered By DFRobot © 2008-2017

SEN0129

Mfr. #:
Manufacturer:
DFRobot
Description:
Multiple Function Sensor Development Tools Analog Gas Sensor MQ4
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet