1. Introduction
CAN SPI click 5V is an accessory board
in mikroBus™ form factor. It is the best
solution for adding CAN connectivity to your
microcontroller with SPI interface. Board
features MCP2551 CAN transciever circuit
which provides CAN serial communication
physical layer in accordance with the ISO
11898 standard. It is designed for operation
in especially-harsh environments, providing
reliable solution. Board is designed to use 5V
power supply only.
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all the pins are aligned
correctly, push the board all the way
into the socket.
3. Plugging the board in
2 3
2. Soldering the headers
1
4. Features and applications
CAN SPI click board features MCP2515 CAN
controller with SPI interface and supports
1Mb/s operation. It features screw terminals
for easier connectivity, power LED and node
termination jumper. Up to 112 nodes can be
connected. Mentioned features make this
board ideal for industrial automation, home
automation as well as in automotive and
mobile machine industry.
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down, so that
bottom side is facing you upwards. Place
shorter parts of the header pins in the
both soldering pad locations.
CAN SPI click
5V
Before using your click board, make sure
to solder the provided 1x8 male headers
to both sides of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
CAN-SPI click 5V Manual
ver. 1.00
