Mechanical Specification
Unit:mm
Pin6 DC output com
External voltage and R
(The max. Sink is 30mA and 50V)
R
V
2.Alarm Signal for AC OK and Battery Low
(1) Alarm Signal is sent out through " AC OK " & " Battery Low " pins.
(2) An external voltage source is required for this function. The maximum applied voltage is 50V and the maximum sink current is 30mA.
(3) Table2.1 explains the alarm function built in the power supply
AC OK (Battery low)
Function
Output of alarm
(0.3V max. at 30mA)
(0.3V max. at 30mA)
voltage 50V max.)
voltage 50V max.)
Low
Low
High or open(External applied
High or open(External applied
Description
The signal is "Low" when the power supply
The signal is "Low" when the voltage of
The signal is "High" when the voltage of
The signal turns to be "High" when the power
turns on
battery is under A:11V, B:22V
battery is above A:11V, B:22V
supply turns OFF
AC OK
Battery
Low
Table 2.1 Explanation ofAlarm Signal
Fig 2.2 Internal circuit ofAC OK (Battery Low)
AC Input Connector (CN1) : JST B3P-VH or equivalent
Pin No.
1
2
3
Assignment
AC/N
No Pin
AC/L
Mating Housing
JST VHR JST SVH-21T-P1.1
or equivalent or equivalent
Terminal
DC Output Connector (CN2) : JST B6P-VH or equivalent
Pin No. Pin No.
1
5
4
2
36
Assignment Assignment
+V
Battery +
-V
AC OK
Bat. Low
Battery -
Mating Housing
JST VHR
or equivalent
Terminal
JST SVH-21T-P1.1
or equivalent
1.HS1,HS2 can not be shorted.
2.HS1 must have safety isolation distance with system case.
3. Gronding required
Mylar film
No.235A-T
15
74.38
2-M3
6
2-M3 L=4
2-M3 L=4
37.6
86.38
23.28
27.06
59.6
30
L-Bracket:
235A-D
4. -V and Bat- can not be shorted
Cover:
24
3 max.
35W Single Output with Battery Charger(UPS Function)
PSC-35 series
CN1
2
3
1
AC FUSE
T2.0A/250V
1
4
5
6
SVR1
CN2
2
3
HS1
4- 3.3ψ
50.8
44.45
3.175
84.6
77.8
3.175
FS1
T4A/250V
FS100
Installation Manual
Please refer to : http://www.meanwell.com/manual.html
File Name:PSC-35-SPEC 2018-01-12
