4/6
www.rohm.com
○
c
2012 ROHM Co., Ltd. All rights reserved.
2012.03 - Rev.I
Data Sheet TCFG Series D Case
Temperature
Stability
−
Shall be satisfied the voltage on "Standard list"
Less than 1000% of initial limit
Less than 1250% of initial limit
+125
°C
Apply the specified surge voltage via the serial
resistance of 1kΩ every 5±0.5min.for 30±5 s.
each time in the atmospheric condition of 85±2°C.
Repeat this procedure 1,000 times.
After the specimens, leave it at room temperature fo
over 24h and then measure the sample.
Surge
Voltage
There should be no significant abnormality.
Within 0/−20%of initial value
−55
°C
+85
°C
Shall be satisfied the voltage on "Standard list"
Within +12/0%of initial value
Within +20/0%of initial value
Within
±10%of initial value
Shall be satisfied the voltage on "Standard list"
Loading at
High
temperature
There should be no significant abnormality.
After applying the rated voltage for 2000+72/0h
without discontinuation via the serial resistance
of 3Ω or less at a temperature of 85
±
2
°C
, leave
the sample at room temperature/humidity for
over 24h and measure the value.
Within
±10%of initial value
Terminal
Strength
The measured value should be stable.
A force is applied to the terminal until it bends
to 1mm and by a prescribed tool maintain the
condition for 5s. (See the figure below.)
Temp.
ΔC / C
L.C
Temp.
ΔC / C
tanδ
L.C
ΔC / C
L.C
Temp.
Appearance
ΔC / C
tanδ
L.C
tanδ
tanδ
Appearance
ΔC / C
L.C
tanδ
Capacitance
Appearance
There should be no significant abnormality.
1
F (Apply force)
(Unit : mm)
20
50
R230
45 45
Thickness 1.6mm
Adhesiveness The terminal should not come off.
Apply force of 5N in the two directions shown
in the figure below for 10
±
1s after mounting
the terminal on a circuit board.
Apply force
a circuit board
product
C105
YAA
As per 4.29 JIS C 5101-1
As per 4.13 JIS C 5101-3
As per 4.26 JIS C 5101-1
As per 4.14 JIS C 5101-3
As per 4.23 JIS C 5101-1
As per 4.15 JIS C 5101-3
As per 4.35 JIS C 5101-1
As per 4.9 JIS C 5101-3
As per 4.34 JIS C 5101-1
As per 4.8 JIS C 5101-3
Item Performance
Test conditions
(based on JIS C5101-1 and JIS C5101-3)
Less than 150% of initial limit
Less than 150% of initial limit
TCFGD1E476
: Less than 150% of initial limit
Others
: Less than initial limit
TCFGD1E476
: Less than 150% of initial limit
Others
: Less than 125% of initial limit
