Product Data Sheet
Amphenol
®
Industrial Amphe-PPM
Quick Disconnect Connectors
No. 195
The Amphe-PPM is a rapid mate, push/pull
connector which provides positive mating in
limited space and ease of use. The design
features of the Amphe-PPM allow consumers
to save cost in space savings and in installa-
tion.
Amphe-PPM, the high performance signal and
power interconnection solution, is ideally suited
to many commercial and industrial applications
including, but not limited to:
• Medical Equipment
• Instrumentation/Test & Measurement
• Communication Equipment
The Amphe-PPM continues Amphenol’s
commitment of providing new products to meet
customer and market demands for new emerg-
ing technologies and advancing applications.
Notice: Specifications are subject to change without notice. Contact your nearest Amphenol Corporation Sales Office for the latest specifications. All statements, information and data given herein are believed to be accurate and
reliable but are presented without guarantee, warranty, or responsibility of any kind, expressed or implied. Statements or suggestions concerning possible use of our products are made without representation or warranty that any such
use is free of patent infringement and are not recommendations to infringe any patent. The user should assume that all safety measures are indicated or that other measures may not be required. Specifications are typical and may not
apply to all connectors.
AMPHENOL is a registered trademark of Amphenol Corporation.
@2006 Amphenol Corporation Printed in U.S.A. 4/2006
Amphenol
Features and Benefits of Amphe-PPM Connectors
• Push/pull rapid mate connector system - high performance of 500 + mating cycles
• Sealed or non-sealed connector versions -
NON-SEALED VERSION:
• Available in 12mm and 16mm shell sizes
• From 2 up to 12 contacts of 1.0mm to 2.5mm diameter (see back side for insert arrangement charts)
• Jam nut receptacle and straight plug are available with a rubber boot or standard
cable clamp rear accessory
• Non-reflective nickel or black epoxy finish
• IP55 rated
SEALED VERSION:
• Available in 10mm, 12mm, 16mm and 18mm shell sizes
• From 2 up to 14 contacts of 0.8mm to 2.5mm diameter (see back side for insert arrangement charts)
• Jam nut receptacle and straight plug come with jacketed cable PG sealing gland
• Non-reflective nickel finish only
• IP67 rated
• Three shell styles available: box mount and jam nut receptacles and a straight plug
• Designed to IEC 61984
• Inserts have a UL94V-0 flammability rating
• Operating temperature: –40° to 100°C
• Solder contacts standard, crimp by special request
• Non-magnetic product standard
