Compact timer
protective cover
• 8P cap • Rear terminal socket: M3.5
The terminal socket can be used for two
installation methods for the back and the
front!
Tolerance: ±0.1 ±.004
AD8-RC
N-TC
AT78041
When a flush type mounting frame is used for
the exposed type, 8P cap should be installed.
The dimensions B and C are
shown in the table below.
(Unit: mm, inch)
When installing 8P cap:
Features
1. The cover prevents the timer from
operating improperly after setting the
time. It also works as a compact dust
cover.
2. The cover is applicable for all types
of the fingertip flush type mounting
frames for the compact timer.
Press the points on the protective cover
(indicated by arrows) to bend the ribs,
and hook the ribs inside the mounting
frame window. The protective cover can
be installed if the timer is inserted into
the mounting frame.
Installation
Dimensions
(Unit: mm, inch)
Tolerance: ±0.3 ±.012
Installation
1. Insert the mounting frame surface
into the panel from its front surface.
Removal
Remove the timer in the reverse order of installation.
3. Hang the hooks on the timer base
to secure the timer to the flush type
mounting frame.
2. After installing the panel, insert the
timer to be used from the back of the
panel.
Note: The panel which is
installed onto the flush type
mounting frame for the timer
cannot be inserted.
(However, the installation
order is not specified when
the flush type mounting
frame (type S) is used.)
When an applicable timer comes in con-
tact with the collar of the mounting
frame, stop the timer by pressing the
upper and lower hooks in the direction
indicated by arrow. Use the terminal
socket at the back (AT78041) or the 8P
cap (AD8-RC) for the connection wiring.
