PCA2002 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2011. All rights reserved.
Product data sheet Rev. 8 — 25 November 2011 15 of 30
NXP Semiconductors
PCA2002
32 kHz watch circuit with programmable output period and pulse width
11. OTP programming characteristics
[1] Program each word once only.
Table 11. Specifications for OTP programming
Symbol Parameter
[1]
Conditions Min Typ Max Unit
V
DD
supply voltage during programming procedure 1.5 - 3.0 V
V
P(prog)(start)
programming supply voltage (start) 6.6 - 6.8 V
V
P(prog)(stop)
programming supply voltage (stop) 6.2 - 6.4 V
V
P(mod)
supply voltage modulation for entering instructions, referred
to V
DD
320 350 380 mV
V
prestore
prestore voltage for prestore pulse 6.2 - 6.4 V
V
store
supply voltage for writing to the OTP cells 9.9 10.0 10.1 V
I
store
store current for writing to the OTP cells - - 10 mA
t
p(start)
start pulse width 8 10 12 ms
t
p(stop)
pulse width of stop pulse 0.05 - 0.5 ms
t
mod
modulation pulse width 25 30 40 s
t
w(prestore)
prestore pulse width 0.05 - 0.5 ms
t
w(store)
store pulse width for writing to the OTP cells 95 100 110 ms
t
0
time 0 waiting time after start pulse 20 - 30 ms
t
1
time 1 pulse distance for incrementing
the state counter
0.6 0.7 0.8 ms
t
2
time 2 pulse distance for clocking the
data register with data = logic 0
1.6 1.7 1.8 ms
t
3
time 3 pulse distance for clocking the
data register with data = logic 1
2.6 2.7 2.8 ms
t
4
time 4 waiting time for writing to OTP
cells
0.1 0.2 0.3 ms
SR slew rate for modulation of the supply
voltage
0.5 - 5.0 V/s
R
mod
modulation resistance supply current modulation
read-out resistor
18 30 45 k