DRAM Operating Conditions
Recommended AC operating conditions are given in the DDR3 component data sheets.
Component specifications are available at micron.com. Module speed grades correlate
with component speed grades, as shown below.
Table 10: Module and Component Speed Grades
DDR3 components may exceed the listed module speed grades; module may not be available in all listed speed grades
Module Speed Grade Component Speed Grade
-2G1 -093
-1G9 -107
-1G6 -125
-1G4 -15E
-1G1 -187E
-1G0 -187
-80C -25E
-80B -25
Design Considerations
Simulations
Micron memory modules are designed to optimize signal integrity through carefully de-
signed terminations, controlled board impedances, routing topologies, trace length
matching, and decoupling. However, good signal integrity starts at the system level.
Micron encourages designers to simulate the signal characteristics of the system's
memory bus to ensure adequate signal integrity of the entire memory system.
Power
Operating voltages are specified at the DRAM, not at the edge connector of the module.
Designers must account for any system voltage drops at anticipated power levels to en-
sure the required supply voltage is maintained.
4GB, 8GB (x72, ECC, SR) 240-Pin DDR3L RDIMM
DRAM Operating Conditions
PDF: 09005aef83ad1229
ksf18c512_1gx72pz.pdf - Rev. K 8/15 EN
13
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2009 Micron Technology, Inc. All rights reserved.