RFM products are now
Murata products.
©2010-2015 by Murata Electronics N.A., Inc.
SF2176E (R) 12/9/15 Page 1 of 6
www.murata.com
Electrical Characteristics -40 to +85°C
Characteristic Sym Notes Min Typ Max Units
Center Frequency
F
C
433.92 MHz
Maximum Insertion Loss, 433.12 to 434.72 MHz
IL
MAX
2.2 2.9 dB
Amplitude Ripple, 433.12 to 434.72 MHz 0.4 1.0
dB
P-P
VSWR, 433.12 to 434.72 MHz 1.6 2.0
Attenuation Referenced to 0 dB:
10.00 to 380.00 MHz 58 61
dB
380.00 to 423.42MHz 46 50
443.42 to 453.42 MHz 25 30
453.42 to 460.00 MHz 35 40
460.00 to 700.00 MHz 50 54
700.00 to 1000.00 MHz 42 46
Source Impedance
Z
S
50
Load Impedance
Z
L
50
Case Style SM3030-6 3.0 x 3.0 mm Nominal Footprint
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator A09, YWWS
Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel
Reel Size 13 Inch 3000 Pieces/Reel
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
NOTES:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 and measured with 50 network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4. "LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd.
SM3030-6
• Low-loss RF SAW Filter
• Surface-mount 3.0 x 3.0 x 1.3 mm Package
• Complies with Directive 2002/95/EC (RoHS)
• Complies with AEC-Q200
Absolute Maximum Ratings
Rating Value Units
Input Power Level 10 dBm
DC Voltage on any Non-ground Terminal 3 V
Operating Temperature Range -40 to +105 °C
Storage Temperature Range in Tape and Reel -40 to +85 °C
Usable Temperature Range -40 to 125 °C
Solder Reflow Temperature, 10 seconds, 5 cycles maximum 260
°C
433.92 MHz
SAW Filter
SF2176E
Pb
Copyright © Murata Manufacturing Co., Ltd. All Rights Reserved 2013
