DATASHEET
IEC Inlet Filters FN 9226
HF Performance EMC/EMI Filter
Rated currents up to 10 A
Faston connection
Optional PCB through hole connection
Good HF coupling to the equipment housing
Optional medical versions (B type)
Performance indicators
Technical specifications
Maximum continuous operating voltage
250 VAC, 50/60 Hz
Operating frequency
DC to 400 Hz
Rated currents
1 to 10 A @ 50°C max.
Approvals by rated current
1 to 10 A (ENEC, UL, CSA)
High potential test voltage
P –> PE 2000 VAC for 2 sec (standard types)
P –> N 760 VAC for 2 sec
P –> PE 2500 VAC for 2 sec (B types)
Protection category
IP 40 according IEC 60529
Temperature range (operation and storage)
-25°C to +85°C (25/85/21)
Design corresponding to
UL 1283, CSA 22.2 No. 8 1986, IEC/EN 60939
Flammability corresponding to
UL 94 V-2 or better
MTBF @ 40°C/230 V (Mil-HB-217F)
800,000 hours
Approvals
The FN 9226 IEC inlet filter combines an IEC inlet and
mains filter with excellent filter attenuation in a small
form factor. The FN 9226 is designed for printed
circuit board mounting with good HF coupling to the
equipment housing. Choosing the FN 9226 power
entry module brings you the rapid availability of a
standard filter associated with the necessary safety
acceptances. Standard IEC connector filters are a
practical solution helping you to pass EMI system
approval in a short time. A wide selection on current
ratings, output connections and low leakage versions
for medical applications helps you to select the
desired solution for your application.
Features and benefits
High conducted attenuation performance, based
on chokes with high saturation resistance and
excellent thermal behavior
Rear flange mounting
Optional low leakage current versions for medical
applications
Faston connection or PCB through hole pins
Good HF coupling
Rated currents up to 10 A
Custom-specific versions are available on request
Typical applications
Portable electrical and electronic equipment
Small to medium-sized machines and household
equipment
Single-phase power supplies, switch-mode power
supplies
Consumer goods
Test and measurement equipment
EDP and office equipment
Medical equipment
Rack mounting equipment
Typical electrical schematic
