SHORT FORM DATA SHEET
82V3399 REVISION 9 01/05/16 9 ©2016 Integrated Device Technology, Inc.
Synchronization Management WAN PLL and
Clock Generatiion for IEEE-1588
82V3399
This short form datasheet is intended to provide an overview only. Additional details are available from IDT. Contact information may
be found on the last page.
FEATURES
HIGHLIGHTS
• Single chip PLL:
• Features 0.5 mHz to 560 Hz bandwidth
• Provides node clock for ITU-T G.8261/G.8262 Synchronous
Ethernet (SyncE)
• Exceeds GR-253-CORE (OC-192) and ITU-T G.813 (STM-64)
jitter generation requirements
• Provides node clocks for Cellular and WLL base-station (GSM
and 3G networks)
• Provides clocks for DSL access concentrators (DSLAM), espe-
cially for Japan TCM-ISDN network timing based ADSL equip-
ments
• Provides clocks for 1 Gigabit and 10 Gigabit Ethernet applica-
tions
• It supports clock generation for IEEE-1588 application
MAIN FEATURES
• Provides an integrated single-chip solution for Synchronous Equip-
ment Timing Source, including Stratum 3, 4E, 4, SMC, EEC-Option
1 and EEC-Option 2 Clocks
• Provides SONET clocks with less than 1 ps of RMS Phase Jitter
(12 kHz - 20 MHz)
• Supports 1PPS input and output
• Employs PLL architecture to feature excellent jitter performance
and minimize the number of the external components
• Integrates T0 DPLL and T4 DPLL; T4 DPLL locks independently or
locks to T0 DPLL
• Supports programmable DPLL bandwidth (0.5 mHz to 560 Hz in 19
steps) and damping factor (1.2 to 20 in 5 steps)
• Supports 1.1X10
-5
ppm absolute holdover accuracy and 4.4X10
-8
ppm instantaneous holdover accuracy
• Supports hitless reference switching to minimize phase transients
on T0 DPLL output to be no more than 0.61 ns
• Supports programmable input-to-output phase offset adjustment
• Limits the phase and frequency offset of the outputs
• Provides OUT1~OUT6 output clocks whose frequencies cover from
1 Hz (1PPS) to 644.53125 MHz
• Includes 25 MHz, 125 MHz and 156.25 MHz for CMOS outputs
• Includes 25.78125 MHz, 128.90625 MHz, 161.1328125 MHz, for
CMOS outputs
• Includes 25 MHz,125 MHz, 156.25 MHz, 312.5 MHz and 625
MHz for differential outputs
• Includes 25.78125 MHz, 128.90625 MHz, 161.1328125 MHz,
322.265625 MHz and 644.53125 MHz for differential outputs
• Provides IN1~IN6 input clocks whose frequencies cover from 1 Hz
(1PPS) to 625 MHz
• Includes 25 MHz, 125 MHz and 156.25 MHz for CMOS inputs
• Includes 25 MHz, 156.25 MHz, 312.5 MHz and 625 MHz for dif-
ferential inputs
• Internal DCO can be controlled by an external processor to be used
for IEEE-1588 clock generation
• Supports Forced or Automatic operating mode switch controlled by
an internal state machine. It supports Free- Run, Locked and Hold-
over modes
• Supports manual and automatic selected input clock switch
• Supports automatic hitless selected input clock switch on clock fail-
ure
• Supports three types of input clock sources: recovered clock from
STM-N or OC-n, PDH network synchronization timing and external
synchronization reference timing
• Provides a 2 kHz, 4 kHz, or 8 kHz frame sync input signal, and a 2
kHz or 8 kHz frame sync output signal
• Provides a 1PPS sync input signal and a 1PPS sync output signal
• Provides output clocks for BITS, GPS, 3G, GSM, etc.
• Supports PECL/LVDS and CMOS input/output technologies
• Supports master clock calibration
• Supports Master/Slave application (two chips used together) to
enable system protection against single chip failure
• Supports Telcordia GR-1244-CORE, Telcordia GR-253-CORE,
ITU-T G.812, ITU-T G.8262. ITU-T G.813 and ITU-T G.783 recom-
mendations
OTHER FEATURES
• I2C and Serial microprocessor interface modes
• IEEE 1149.1 JTAG Boundary Scan
• Single 3.3 V operation with 5 V tolerant CMOS I/Os
• 72-pin QFN package, green package options available
APPLICATIONS
• 1 Gigabit Ethernet and 10 Gigabit Ethernet
• BITS / SSU
• SMC / SEC (SONET / SDH)
• DWDM cross-connect and transmission equipment
• Synchronous Ethernet equipment
• Central Office Timing Source and Distribution
• Core and access IP switches / routers
• Gigabit and terabit IP switches / routers
• IP and ATM core switches and access equipment
• Cellular and WLL base-station node clocks
• Broadband and multi-service access equipment
