Specification Control Drawing
Tyco Electronics Corporation
300 Constitutional Drive
Menlo Park, CA 94025 USA
Title: TAK-Caps
Adhesive-Lined Cap
Tyco Electronics reserves the right to amend this drawing at any
time. Users should evaluate the suitability of the product for their
application
Document No :
TAK-Caps
Cage Code:
06090
Scale:
None
Size:
A
Rev. Date:
30-Oct-96
Rev.:
E
Sheet:
1 of 1
If this document is printed it becomes uncontrolled. Check for the latest revision.
TAK-Caps
Adhesive-Lined Cap
Table 1: Dimensions
(inches)
Size
Expanded
I.D. Minimum
(D)
Recovered
I.D.
Maximum (d)
Recovered Wall with
adhesive Minimum
(W)
Open Barrel
Length
As Supplied
Minimum (1)
Overall Length
As Supplied
Maximum (L)
1/8 .125 .040 .019 .620 1.060
3/16 .187 .070 .024 .620 1.060
Color:
Natural
Material:
The caps shall be fabricated from modified polyvinylidene fluoride with an interior
coating of thermoplastic adhesive.
Table 2: Properties:
Values apply only to outer jacket.
Properties Unit Requirements Method of Test
Longitudinal Change
3 minutes at 200°C
Percent +0, -10 ASTM D 2671
Tensile Strength
PSI 5000 minimum ASTM D 2671
1-inch bench marks
Ultimate Elongation Percent 150 minimum 1-inch jaw separation
2-inches/minute jaw separation
speed
Dielectric Strength Volts/mil 500 minimum ASTM D 2671
Note 1
Volume Resistivity ohm-cm 10
13
ASTM D 2671
Note 1: Recover the specimens on metal mandrels for 10 minutes at 175 ±
3°C, or until the specimens are completely shrunk on the mandrel.
Acceptance Tests:
Visual Appearance
Dimensions
