114- 40005
Rev H2 of 9
2. REFERENCE MATERIAL
2.1. Revision Summary
This paragraph is reserved for a revision summary of changes and additions made to this specification. The
following changes were made for this revision.
S Updated document to corporate requirements.
2.2. Customer Assistance
Reference Part Number 746285 and Product Code 5754 are representative numbers of the AMP--LATCH line
of receptacle connectors. Use of these numbers will identify the product line and expedite your inquiries
through a service network established to help you obtain product and tooling information. Such information can
be obtained through a local TE Representative (Field Sales Engineer , Field Applications Engineer , etc.) or,
after purchase, by calling the Product Information number on the bottom of page 1.
2.3. Drawings
Customer Drawings for each product part number are available from the service network. The information
contained in Customer Drawings takes priority if there is a conflict with this specification or with any technical
documentation supplied by TE.
2.4. Specifications
Product Specification108--40000 for AMP--LATCH Novo and Novo Stackable Receptacles covers test data and
performance requirements.
2.5. Instructional Material
The following list includes available instruction sheets (408--series) that provide assembly procedures for
product, operation, maintenance and repair of tooling, as well as setup and operation procedures of
applicators; and customer manuals (409--series) that provide setup, operation, and maintenance of machines.
Document Number
Document Title
408--6732 Pneumatic Auto--Cycle Unit
408--7763 Pneumatic Applicator Frame Assembly
408--7777 Manual Arbor Frame Assembly
408--9828 AMP--LATCH Universal Tooling Kit
408--9831 AMP--LATCH Receptacle Connector--Specific Kits
409--5725 R--CAM 2A Cable Terminating Machine 760700--6
409--5794 R--CAM 3A Cable Terminating Machine 761900--[ ]
3. REQUIREMENTS
3.1. Storage
A. Ultraviolet Light
Prolonged exposure to ultraviolet light may deteriorate the chemical composition used in the housing
material.
B. Shelf Life
Each connector is packaged and shipped in an individual antistatic tube container. To prevent damage to
the housings and contacts, the connectors should remain in the container until ready for installation. Also,
to prevent possible storage contamination, the connectors should be used on a first in, first out basis.
C. Chemical Exposure
Do not store product near any of the following chemicals as they may cause stress corrosion.
Alkalies Ammonia Citrates Phosphates Citrates Sulfur Compounds
Amines Carbonates Nitrites Sulfides Nitrites Tartrates
Where the above environmental conditions exist, phosphor--bronze contacts are recommended instead of brass if
available.
NOTE
i
