M48T129V, M48T129Y Operating modes
Doc ID 5710 Rev 5 7/28
2 Operating modes
Figure 3 on page 6 illustrates the static memory array and the quartz controlled clock
oscillator. The clock locations contain the century, year, month, date, day, hour, minute, and
second in 24-hour BCD format. Corrections for 28, 29 (leap year - valid until 2100), 30, and
31 day months are made automatically. The nine clock bytes (1FFFFh-1FFF9h and 1FFF1h)
are not the actual clock counters, they are memory locations consisting of BiPORT™
READ/WRITE memory cells within the static RAM array.
The M48T129Y/V includes a clock control circuit which updates the clock bytes with current
information once per second. The information can be accessed by the user in the same
manner as any other location in the static memory array. Byte 1FFF8h is the clock control
register. This byte controls user access to the clock information and also stores the clock
calibration setting.
Byte 1FFF7h contains the watchdog timer setting. The watchdog timer can generate either a
reset or an interrupt, depending on the state of the watchdog steering bit (WDS). Bytes
1FFF6h-1FFF2h include bits that, when programmed, provide for clock alarm functionality.
Alarms are activated when the register content matches the month, date, hours, minutes,
and seconds of the clock registers. Byte 1FFF1h contains century information. Byte 1FFF0h
contains additional flag information pertaining to the watchdog timer, the alarm condition
and the battery status. The M48T129Y/V also has its own power-fail detect circuit. This
control circuitry constantly monitors the supply voltage for an out of tolerance condition.
When V
CC
is out of tolerance, the circuit write protects the TIMEKEEPER
®
register data and
external SRAM, providing data security in the midst of unpredictable system operation. As
V
CC
falls below battery backup switchover voltage (V
SO
), the control circuitry automatically
switches to the battery, maintaining data and clock operation until valid power is restored.
Table 2. Operating modes
Note: X = V
IH
or V
IL
; V
SO
= battery backup switchover voltage.
Mode V
CC
EGW
DQ0-
DQ7
Power
Deselect
4.5 to 5.5V
or
3.0 to 3.6V
V
IH
X X High Z Standby
WRITE V
IL
XV
IL
D
IN
Active
READ V
IL
V
IL
V
IH
D
OUT
Active
READ V
IL
V
IH
V
IH
High Z Active
Deselect V
SO
to V
PFD
(min)
(1)
1. See Table 12 on page 23 for details.
X X X High Z CMOS standby
Deselect ≤ V
SO
(1)
X X X High Z Battery backup mode
Obsolete Product(s) - Obsolete Product(s)