B132
DF6 Series●3.96mm Pitch Connector Directly Mounted on Board
BPrecautions
1.Recommended soldering
condition
2.Cleaning condition
3.Connecting condition
4.Precations
Flow: 250ç for 3 seconds
Manual soldering: 290ç for 2 seconds
■After soldering, if a load is given to the cable where connector and cable contain heat, the jacket holding
member will be loosened. After soldering, the operation should be performed, after connector returns to room
temperature.
Refer to the "Nylon Connector Use Hand book".
Don't use solvent to degrade the cable jacket like trichloroethane.
In addition, avoid heat cleaning with solvent.
Refer to the "Nylon Connector Use Hand book".
Slight discoloration on the insulating materials will not affect form, fit or function of the connectors.
Refer to "Nylon Connector Use Handbook"
The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
Nov.1.2016 Copyright 2016 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
Powered by TCPDF (www.tcpdf.org)
May.1.2017 Copyright 2017 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
Powered by TCPDF (www.tcpdf.org)
