EVAL-ADA4571-2 User Guide
One Technology Way • P. O. Box 9106 • Norwood, MA 02062-9106, U.S.A. • Tel: 781.329.4700 • Fax: 781.461.3113 • www.analog.com
Evaluation Board for the ADA4571-2 Integrated AMR Angle Sensor and
Signal Conditioner
PLEASE SEE THE LAST PAGE FOR AN IMPORTANT
WARNING AND LEGAL TERMS AND CONDITIONS.
Rev. 0 | Page 1 of 9
FEATURES
USB 2.0 interface
Jumper or computer controlled temperature compensation
mode enable
Jumper or computer controlled power-down mode enable
Measurement test points and coaxial connectors
EVALUATION KIT CONTENTS
ADA4571-2 magnetic stimulus
Dipole magnet
Hand movable mounting
Read back electronics
ADDITIONAL EQUIPMENT NEEDED
6 V to 12 V bench supply (optional)
SDP-S controller board
USB cable (supplied with the SDP-S controller board)
LabVIEW 2013 software downloadable from ADA4571-2
product page
GENERAL DESCRIPTION
The EVA L-ADA4571-2 shows the ADA4571-2 in an end of shaft
magnet configuration. The evaluation kit is composed of an
ADA4571-2 motherboard, a magnetic stimulus on a hand turnable
mount, a USB interface, and an SDP-S controller board. The
required LabVIEW 2013 graphical user interface (GUI) software
for Windows® is available on the ADA4571-2 product page.
The EVA L-ADA4571-2 features an on-board 5 V regulator, a
6-channel simultaneous sampling analog-to-digital converter
(ADC), and jumpers for enabling the temperature compensation
and power-down modes within the ADA4571-2. The motherboard
also features test points and unpopulated coaxial connectors for
the six outputs of the device.
The SDP-S controller board controls the ADC on the motherboard
reading back the ADA4571-2 outputs, to change the digital inputs
to the ADA4571-2, interface with the GUI, and to supply power
to the evaluation board through the USB connection.
ADA4571-2 END OF SHAFT EVALUATION SYSTEM
Figure 1.
