Index
I-2 Blackfin Landscape LCD EZ-Extender Manual
J
jumpers
diagram of locations, 2-3
JP10 (AD7879 PENIRQ), 2-9
JP11 (AD7147 INT), 2-9
JP12 (oscillator disable), 2-10
JP13 (LCD backlight enable), 2-10
JP1 (AD7147 ADDR0), 2-4
JP2 (LCD SPI chip select), 2-4
JP3 (AD7879 SPI Chip Select) jumper,
2-5
JP5 (LCD display reset), 2-5
JP6 (PPICLK disable), 2-6
JP7 (AD7147 ADDR1), 2-7
JP8 (serial ROM address), 2-7
JP9 (serial ROM write protect), 2-8
L
LCD display
interface, 1-3
backlight enable jumper (JP13), 2-10
connector (P1), 1-3, 1-4, 2-14
disabling oscillator jumper (JP12), 2-10
reset jumper (JP5), 2-5
reset pin (P1.28), 2-6
SPI chip select jumper (JP2), 2-4
low speed IO connector (J2), 2-13
O
oscillator (U2)
disable jumper (JP12), 2-10
PPICLK disable jumper (JP6), 2-6
P
PPICLK disable jumper (JP6), 2-6
PPI interface
expansion interface II connector (J1),
2-13
stamp connector (J3), 2-13
product overview, x
programmable controller, 1-4
push buttons (PB1-4), 1-5
S
schematic, of Landscape LCD
EZ-Extender, B-1
serial ROM
interface, 1-5
addr jumper (JP8), 2-7
write protect jumper (JP9), 2-8
setup, of Landscape LCD EZ-Extender, 1-2
SPI select pins (SPISEL1-3), 2-4, 2-5
system architecture, 2-2
T
technical support, xiii
two-wire interface (TWI), 1-4, 2-4, 2-6,
2-7
V
VDDIO voltage domain, 1-3
