Landscape LCD EZ-Extender Setup
1-2 Blackfin Landscape LCD EZ-Extender Manual
Landscape LCD EZ-Extender Setup
It is very important to set up all components of the system containing the
Blackfin Landscape LCD EZ-Extender, then apply power to the system.
The following procedure is recommended for the correct setup.
1. Read the applicable design interface section in this chapter—the
text provides an overview of the interface capabilities.
2. Read “System Architecture” on page 2-2 to understand the physical
connections of the extender board. For detailed information, refer
to “Landscape LCD EZ-Extender Schematic” on page B-1.
3. Set the jumpers on the extender board. Use the block diagram in
Figure 2-1 on page 2-2 in conjunction with “Jumper Settings” on
page 2-3.
4. Set the switches and jumpers on the EZ-KIT Lite/EZ-Board. If not
already, familiarize yourself with the board documentation and
schematic drawings (see “Product Information”).
Compare the parallel peripheral interface (PPI) or expansion inter-
face II connector signals of the extender board with the EZ-KIT
Lite/EZ-Board signals to ensure there is no contention. For exam-
ple, it may be necessary to disable other devices connected to the
PPI or expansion II connector of the processor or disable the push
buttons on the EZ-KIT Lite/EZ-Board.
5. Install the extender on the EZ-KIT Lite/EZ-Board via the PPI or
expansion II connector.
6. Configure any other interfacing boards; for example, another
EZ-Extender board.
7. Power your system.
