JTAG-Booster for Analog Devices ADSP-21xxx
JTAG_ADSP-21xxxa.doc 9
1.5. First Example with Analog Devices ADSP-21060/21061/21062
In the following simple example it is assumed that the JTAG-Booster is
connected to LPT1 of your PC and target power is on.
Typing
JTAG060 /P MYAPP.BIN
at the DOS prompt results in the following output:
JTAG060 --- JTAG utility for Analog Devices ADSP-21060/21061/21062
Copyright FS FORTH-SYSTEME GmbH, Breisach
Version 4.xx of mm/dd/yyyy
(1) Configuration loaded from file JTAGxxx.INI
(2) Target: Analog Devices SHARC EZ-KIT
(3) Using LPT at I/O-address 0378h
(4) JTAG Adapter detected
(5) 1 Device detected in JTAG chain
Device 0: Part without an ICODE register (1st Bit is 0)
(6) Analog Devices ADSP-21060/21061/21062 is selected
(7) Sum of instruction register bits : 5
(8) CPU position : 0
(9) Instruction register offset : 0
(10) Length of boundary scan reg : 363
Looking for a known flash device. Please wait..
(11) AMD 29F010 detected
(12) Bus size is 8 Bit
(13) Erasing Flash-EPROM Block #:0
Programming File MYAPP.BIN
65536 Bytes programmed
Programming ok
Erase Time : 1.3 sec
Programming Time : 201.6 sec
