JTAG-Booster for Analog Devices ADSP-21xxx
JTAG_ADSP-21xxxa.doc 59
2.9. Toggle CPU pins
Usage: JTAGxxx /BLINK /PIN=pinname [optionlist]
This command allows to test the hardware by blinking with LEDs or toggling
CPU signals. Faster signals can be generated by setting the delay option to
zero. This can be a very helpful feature to watch signals on an oscilloscope.
The signal on the defined pin has an duty cycle of 1/2: The level is 67% high and
33% low.
Please Note: Not every pin of the Analog Devices ADSP-21xxx may be specified
as an output pin.
Options:
/PIN=pin_name
CPU pin to toggle. If the option /PIN= is not specified an error message occurs.
Most pins of the list in chapter 1.10 “Initialization file JTAGxxx.INI” can be used.
If you type /PIN= without any pin declaration a list of the CPU pins is displayed.
/DELAY=dddddd
5
Time to wait to next change of signal. This option can be adjusted to get
optimum signals for measures with the oscilloscope.
Default: /DELAY=10000
Example:
JTAGxxx /BLINK /PIN=FLAG3 /DELAY=0
This example toggles the FLAG3 pin very fast which can be followed by the use
of an oscilloscope.
5
dddddd=number base is decimal
