New Product
TSOP62.., TSOP64..
www.vishay.com
Vishay Semiconductors
Rev. 1.0, 15-Mar-12
1
Document Number: 82463
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
IR Receiver Modules for Remote Control Systems
MECHANICAL DATA
Pinning
1 = GND, 2 = N.C., 3 = V
S
, 4 = OUT
Please see the document “Product Transition Schedule” at
www.vishay.com/ir-receiver-modules/
for up-to-date info,
when this product will be released.
FEATURES
• Low supply current
• Photo detector and preamplifier in one package
• Internal filter for PCM frequency
• Improved shielding against EMI
• Supply voltage: 2.5 V to 5.5 V
• Improved immunity against ambient light
• Insensitive to supply voltage ripple and noise
• Taping available for top view and side view assembly
• Material categorization: For definitions of compliance
please see www.vishay.com/doc?99912
DESCRIPTION
These products are miniaturized SMD-IR receivers for
infrared remote control systems. A PIN diode and a
preamplifier are assembled on a lead frame, the epoxy
package acts as an IR filter.
The demodulated output signal can be directly decoded by
a microprocessor. The TSOP62.., TSOP64.. series are
compatible with all common IR remote control data formats.
The TSOP64.. series are optimized to suppress almost all
spurious pulses from energy saving fluorescent lamps but
will also suppress some data signals.
This component has not been qualified according to
automotive specifications.
BLOCK DIAGRAM APPLICATION CIRCUIT
16797
1
2
3
4
PARTS TABLE
CARRIER FREQUENCY STANDARD APPLICATIONS (AGC2/AGC8) NOISY ENVIRONMENTS AND SHORT BURSTS (AGC4)
30 kHz TSOP6230 TSOP6430
33 kHz TSOP6233 TSOP6433
36 kHz TSOP6236 TSOP6436
38 kHz TSOP6238 TSOP6438
40 kHz TSOP6240 TSOP6440
56 kHz TSOP6256 TSOP6456
33 kΩ
V
S
OUT
Demo
-
GND
pass
AGCInput
PIN
Band
dulator
Control circuit
3
4
1
16839-1
C
1
IR receiver
GND
Circuit
µC
R
1
+ V
S
GND
Transmitter
with
TSALxxxx
V
S
V
O
17170-10
OUT
The external components R
1
and C
1
are optional
to improve the robustness against electrical overstress
(typical values are R
1
= 100 Ω, C
1
= 0.1 µF).