ADN2892 Data Sheet
Rev. C | Page 12 of 16
PCB Layout
Figure 19 shows the recommended PCB layout. The 50 Ω
transmission lines are the traces that bring the high frequency
input and output signals (PIN, NIN, OUTP, and OUTN) from a
terminated source to a terminated load with minimum reflection.
To avoid a signal skew between the differential traces, each
differential PIN/NIN and OUTP/OUTN pair should have
matched trace lengths from a differential source to a differential
load. C1, C2, C3, and C4 are ac coupling capacitors in series
with the high speed, signal input/output paths. To minimize the
possible mismatch, the ac coupling capacitor pads should be the
same width as the 50 Ω transmission line trace width. To reduce
supply noise, a 1 nF decoupling capacitor should be placed as
close as possible to the VCC pins on the same layer and not
through vias. A 0.1 µF decoupling capacitor can be placed on
the bottom of the PCB directly underneath the 1 nF capacitor.
All high speed, CML outputs have internal 50 Ω resistor
termination between the output pin and VCC. The high speed
inputs, PIN and NIN, also have the internal 50 Ω termination to
an internal reference voltage.
As with any high speed, mixed-signal design, keep all high
speed digital traces away from sensitive analog nodes.
Soldering Guidelines for the LFCSP
The lands on the 16-lead LFCSP are rectangular. The PCB pad
for these should be 0.1 mm longer than the package land length
and 0.05 mm wider than the package land width. The land should
be centered on the pad. This ensures that the solder joint size is
maximized. The bottom of the LFCSP has a central exposed pad.
The pad on the printed circuit board should be at least as large
as the exposed pad. Users must connect the exposed pad to VEE
using filled vias so that solder does not leak through the vias
during reflow. This ensures a solid connection from the exposed
pad to VEE.
PAD COATING AND PB-FREE SOLDERING
Table 5.
Pad Coating Matt-Tin
Pb-Free Reflow Portfolio J-STD-20B
04986-009
1
FILLED VIAS TO
GND
EXPOSED PAD
PIN
NIN
VIA TO C12, R2
ON BOTTOM
VIAS TO BOTTOM
DOUBLE-VIA TO GND
TO REDUCE INDUCTANCE
C3
C8
C4
C1
C2
OUTP
DOUBLE-VIAS TO REDUCE
INDUCTANCE TO SUPPLY
AND GND
R1, C9, C10 ON BOTTOM
TO ROSA
PLACE C7 ON
BOTTOM OF BOARD
UNDERNEATH C8
OUTN
PLACE C5 ON
BOTTOM OF BOARD
UNDERNEATH C6
∼
4mm
TRANSMISSION LINES SAME
WIDTH AS AC COUPLING
CAPS TO REDUCE REFLECTIONS
GND
AVCC
DVCC
GND
C6
Figure 19. Recommended ADN2892 PCB Layout (Top View)