LPF-16-48 Datasheet LPF-16-24, LPF-16-15, LPF-16-30 | P1-P3

■ ModelEncoding

■ Description

■ Features ■ Applications

File Name:LPF-16-SPEC 2018-05-29

16W Constant Voltage + Constant Current LED Driver

LPF-16 series

‧LEDdownlight

‧LEDspotlight

‧LEDdecorativelighting

‧LEDtunnellighting

LPF-16seriesisa16WAC/DCLEDdriverfeaturingthedualmodesconstantvoltageand

constantcurrentoutput.LPF-16operatesfrom90～305VACandoffersmodelswithdifferent

ratedvoltagerangingbetween12Vand54V.Thankstotheefficiencyupto86%,withthe

fanlessdesign,theentireseriesisabletooperatefor-35 ~+70 casetemperatureunder℃ ℃

freeairconvection.Theentireseriesissuitabletoworkforavarietyofapplicationsatdryor

damplocationsandtheoptionalmodelswithIP67ratingisabletofurtherworkatwetlocations.

- 20LPF - 16

Ratedoutputvoltage(12V/15V/20V/24V/30V/36V/42V/48V/54V)

Ratedwattage

Seriesname

‧ConstantVoltage+ConstantCurrentmodeoutput

‧PlastichousingwithClassIIdesign

‧Built-inactivePFCfunction

‧Class2powerunit

‧ FullyencapsulatedwithIP30level,optionalIP67rating

‧Typicallifetime>50000hours

‧5yearswarranty

M M

110

SELV

IP30

IPleveloption

Type

Blank

IPLevel

IP30

IP67

Note

InStock

Byrequest

(CCCoptional)

LPF-16 series

SPECIFICATION

MODEL

OUTPUT

VOLTAGE RANGE Note.5

FREQUENCY RANGE

POWER FACTOR

EFFICIENCY (Typ.)

AC CURRENT

INPUT

INRUSH CURRENT(Typ.)

LEAKAGE CURRENT

EMC IMMUNITY

WORKING TEMP.

WORKING HUMIDITY

STORAGE TEMP., HUMIDITY

TEMP. COEFFICIENT

VIBRATION

MTBF

DIMENSIONOTHERS

NOTE

PACKING

OVER TEMPERATURE

OVER VOLTAGE

47 ~ 63Hz

<0.75mA / 240VAC

Compliance to

EN55015

,EN61000-3-2 Class C (@load≧50%) ; EN61000-3-3,GB17743 and GB17625.1,EAC TP TC 020

20 ~ 95% RH non-condensing

-40 ~ +80℃, 10 ~ 95% RH

±0.03%/℃ (0 ~ 50℃)

10 ~ 500Hz, 2G 12min./1cycle, period for 72min. each along X, Y, Z axes

473.3Khrs min. MIL-HDBK-217F (25℃)

ENVIRONMENT

EMC EMISSION Note.8

SAFETY &

EMC

PROTECTION

SHORT CIRCUIT

I/P-O/P:3.75KVAC

I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH

WITHSTAND VOLTAGE

ISOLATION RESISTANCE

TOTAL HARMONIC DISTORTION

DC VOLTAGE

RATED CURRENT

RATED POWER Note.5

LINE REGULATION

LOAD REGULATION

SETUP, RISE TIME Note.6

HOLD UP TIME (Typ.)

RIPPLE & NOISE (max.) Note.3

VOLTAGE TOLERANCE Note.4

CONSTANT CURRENT REGION Note.2

OVER CURRENT

SAFETY STANDARDS Note.8

COLD START 45A(twidth=200 s measured at 50% Ipeak) at 230VACμ ; Per NEMA 410

MAX. No. of PSUs on 16A

CIRCUIT BREAKER

14 units (circuit breaker of type B) / 24 units (circuit breaker of type C) at 230VAC

MAX. CASE TEMP.

Tcase=+70℃

Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level (surge immunity Line-Line 2KV),EAC TP TC 020

(Please refer to "STATIC CHARACTERISTIC" section)

90 ~ 305VAC 127 ~ 431VDC

1.AllparametersNOTspeciallymentionedaremeasuredat230VACinput,ratedcurrentand25℃ofambienttemperature.

2.Pleasereferto"DRIVINGMETHODSOFLEDMODULE".

3.Ripple&noisearemeasuredat20MHzofbandwidthbyusinga12"twistedpair-wireterminatedwitha0.1uf&47ufparallelcapacitor.

4.Tolerance:includessetuptolerance,lineregulationandloadregulation.

5.De-ratingmaybeneededunderlowinputvoltages.Pleasereferto“STATICCHARACTERISTIC”sectionsfordetails.

6.Lengthofsetuptimeismeasuredatfirstcoldstart.TurningON/OFFthedrivermayleadtoincreaseofthesetuptime.

7.Thedriverisconsideredasacomponentthatwillbeoperatedincombinationwithfinalequipment.SinceEMCperformancewillbeaffectedbythe

completeinstallation,thefinalequipmentmanufacturersmustre-qualifyEMCDirectiveonthecompleteinstallationagain.

8.To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED driver can only be used behind a switch

without permanently connected to the mains.

9.Thisseriesmeetsthetypicallifeexpectancyof>50,000hoursofoperationwhenTcase,particularlytcpoint(orTMP,perDLC),isabout70℃orless.

10.PleaserefertothewarrantystatementonMEANWELL'swebsiteathttp://www.meanwell.com

11.Theambienttemperaturederatingof3.5℃/1000mwithfanlessmodelsandof5℃/1000mwithfanmodelsforoperatingaltitudehigherthan2000m(6500ft).

16W Constant Voltage + Constant Current LED Driver

95 ~ 108%

Hiccup mode, recovers automatically after fault condition is removed

Constant current limiting, recovers automatically after fault condition is removed

PF≧0.97/115VAC, PF≧0.95/230VAC, PF≧0.92/277VAC@full load

(Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section)

THD< 20%(@load≧60%/115VC,230VAC; @load≧75%/277VAC)

(Please refer to “TOTAL HARMONIC DISTORTION(THD)” section)

Tcase=-35 ~ +70℃ (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section)

Shut down o/p voltage, recovers automatically after temperature goes down

148*40*32mm (L*W*H)

15 ~ 18V 17.5 ~ 21V

23 ~ 27V

28 ~ 35V

34 ~ 40V

41 ~ 49V 54 ~ 63V

46 ~ 54V 59 ~ 66V

UL8750, CSA C22.2 No. 250.0-08; ENEC EN61347-1, EN61347-2-13 independent, EN62384,J61347-1,J61347-2-13,

Shut down and latch off o/p voltage, re-power on to recover

12V

LPF-16-12

LPF-16-15

LPF-16-20

LPF-16-24

LPF-16-30

LPF-16-36

LPF-16-42

LPF-16-48

LPF-16-54

6.6 ~12V

15V

8.25 ~ 15V

20V

11 ~ 20V

24V

13.2 ~ 24V

30V

16.5 ~ 30V

36V

19.8 ~ 36V

48V

26.4 ~ 48V

1.34A 1.07A 0.8A 0.67A

0.54A

0.45A

0.34A

16.08W

16.05W 16W 16.08W 16.2W

16.2W

16.32W

150mVp-p 150mVp-p 150mVp-p 150mVp-p 200mVp-p

250mVp-p

±4.0% ±4.0% ±4.0% ±4.0% ±4.0%

±4.0%

±0.5% ±0.5% ±0.5% ±0.5% ±0.5%

±0.5%

±2.0% ±1.5% ±1.0% ±0.5% ±0.5%

±0.5%

54V

29.7 ~ 54V

0.3A

16.2W

350mVp-p

±4.0%

±0.5%

42V

23.1 ~ 42V

0.39A

16.38W

250mVp-p

±4.0%

±0.5%

1500ms, 80ms / 115VAC 500ms, 80ms / 230VAC

16ms/230VAC 16ms /115VAC

84%

86%

86%86% 86%

0.4A / 115VAC 0.25A / 230VAC 0.2A/277VAC

EAC TP TC 004,GB19510.1,GB19510.14 approved,IP67 (optional) ; Design refer to UL60950-1, TUV EN60950-1

0.21Kg; 40pcs/9.4Kg/1.02CUFT

File Name:LPF-16-SPEC 2018-05-29

LPF-16 series

BLOCK DIAGRAM

fosc : 100KHz

16W Constant Voltage + Constant Current LED Driver

※ This series is able to work in either Constant Current mode (a direct drive way) or

Constant Voltage mode (usually through additional DC/DC driver) to drive the LEDs.

DRIVING METHODS OF LED MODULE

Typical output current normalized by rated current (%)

In the constant current region, the highest voltage at the output of the driver

depends on the configuration of the end systems.

Should there be any compatibility issues, please contact MEAN WELL.

100

(min.)

Vo(%)

100

Io(%)

(B)

Constant

Current area

(C)

Hiccup

Protection

(A)

Constant

Voltage area

DETECTION

PWM & PFC

CIRCUIT

O.L.P.

EMI FILTER

RECTIFIERS

POWER

SWITCHING

FILTER

RECTIFIERS

-V

I/P

CONTROL

O.V.P.

O.L.P.

PFC

CIRCUIT

File Name:LPF-16-SPEC 2018-05-29

P1-P3 P4-P6

LPF-16-48

Mfr. #:

Buy LPF-16-48

Manufacturer:

MEAN WELL

Description:

LED Power Supplies 16.32W 48V 0.34A 90-305Vac LED PS

Lifecycle:

New from this manufacturer.

Delivery:

DHL FedEx Ups TNT EMS

Payment:

T/T Paypal Visa MoneyGram Western Union

LPF-16-48

LPF-16-48

Products related to this Datasheet