located within the zone indicated. The pin #1 identifier may be
Unless otherwise specified, tolerance : Decimal ± 0.05
The configuration of the pin #1 identifier is optional, but must be
between 0.25mm and 0.30mm from the terminal tip.
Dimension applies to the metallized terminal and is measured
Dimensions in ( ) for Reference Only.
Dimensioning and tolerancing conform to ASME Y14.5m-1994.
6.
either a mold or mark feature.
3.
5.
4.
2.
Dimensions are in millimeters.1.
NOTES:
BOTTOM VIEW
DETAIL "X"
SIDE VIEW
TYPICAL RECOMMENDED LAND PATTERN
TOP VIEW
Compies to JEDEC MO-229 VCED-2.7.
(4X) 0.15
INDEX AREA
PIN 1
PIN #1
C
SEATING PLANE
BASE PLANE
0.08
SEE DETAIL "X"
C
C
4
6
A
B
0.90 ±0.10
0.05 MAX
0.05 MAX
0.20 REF
2.00
3.00
2X 1.50
8X 0.40 ±0.10
8X 0.25 +0.07/-0.05
INDEX AREA
6X 0.50
(1.65)
(1.50)
(8X 0.60)
(8X 0.25)
(1.80)
(2.80)
(6X 0.50)
1
8
0.10 AMC B
0.10 C
1.80 +0.10/-0.15
1.65 +0.10/-0.15
either a mold or mark feature.
Tiebar shown (if present) is a non-functional feature and may be
located on any of the 4 sides (or ends).