A203
DF12 Series●0.5mm Pitch SMT Board-to-Board Connector
BPrecautions for Use
1.
Recommended Temperature Profile (SMT)
Note1 : UP to 2 cycles of Reflow soldering are possible under the
same conditions, provided that there is a return to normal
temperature between the first and second cycle
.
Note2 : The temperature profile indicates the board surface
temperature at the point of contacts with the connector
terminals.
2.
Recommended Manual Soldering Condition (SMT)
Soldering iron temperature : 350ç, Soldering time : Within 3 seconds
3.Recommended Screen Thickness and 0.12mm
open area ratio(Pattern area ratio) Open area ratio : 70%
4.Board Warp(SMT) Maxmum 0.02mm in the connector center area, based on both connector edges
5.Cleaning Condition Refer to "Nylon Connector Use Hand book".
6.Cautions ■ The receptacle is designed in a structure where contacts are exposed. Touching it with
bare hands would cause contact failure or electrostatic element damage.
■ Where no board is mounted, the insertion or extraction will cause damage or
contact deformation.
■ Avoid retaining the board with the connector only, and fix the board by any other means
than the connector.
■ Excessive scoop insertion or extraction may result in damage.
■ In the manual soldering process, don't carry out the flux coating which will cause a flux
blister on the connector.
■ The color phase of this product may be slightly different from that of the formed product
according to the manufacturing lot. However, the difference doesn't affect the performance.
Nov.1.2016 Copyright 2016 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
Apr.1.2017 Copyright 2017 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
