MAX4614/MAX4615/MAX4616
Low-Voltage, High-Speed, Quad, SPST
CMOS Analog Switches
_______________________________________________________________________________________ 5
PARAMETER SYMBOL MIN TYP MAX UNITS
Analog Signal Range
(Note 3)
V
COM
_,
V
NO
_,
V
NC
_
0V+V
CONDITIONS
COM_ to NO_ or NC_
On-Resistance
R
ON
30 60
Ω
V+ = 2.5V,
I
COM_
= 10mA,
V
NO
= 1.2V
T
A
= +25°C
T
A
= T
MIN
to T
MAX
100
Note 2: The algebraic convention, where the most negative value is a minimum and the most positive value a maximum, is used in
this data sheet.
Note 3: Guaranteed by design.
Note 4: ∆R
ON
= R
ON
(max) - R
ON
(min).
Note 5: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the
specified analog signal range.
Note 6: Leakage parameters are 100% tested at maximum-rated hot temperature and guaranteed by correlation at +25°C.
Note 7: Off-Isolation = 20log
10
(V
COM_
/ V
NO_
), V
COM_
= output, V
NO_
= input to off switch.
Note 8: Between any two switches.
ELECTRICAL CHARACTERISTICS—Single +2.5V Supply
(V+ = +2.5V, V
INH
= 0.7V
CC
, V
INL
= 0.5V, T
A
= T
MIN
to T
MAX
, unless otherwise noted.) (Note 2)
6.5Turn-On Time t
ON
ns
Turn-Off Time t
OFF
ns2.8
ANALOG SWITCH
SWITCH DYNAMIC (Note 3)
V
NO_
or V
NC_
= 1V, T
A
= +25°C
V
NO_
or V
NC_
= 1V, T
A
= +25°C