Electrical Characteristics
Environmental conditions beyond those listed may cause permanent damage to the de-
vice. This is a stress rating only, and functional operation of the device at these or any
other conditions above those indicated in the operational sections of this specification
is not implied. Exposure to absolute maximum rating conditions for extended periods
may affect reliability.
Table 6: SATA Power Consumption
Capacity
Device Sleep
Typical Idle Average Active Average
Active Maximum
(128KB transfer) Unit
256GB 2 55 70 3000 mW
512GB 4000
1024GB 4 65 75 5000 mW
2048GB 25 110 150 6000
Notes:
1. Data taken at 25°C using a 6 Gb/s SATA interface.
2. Active average power measured while running MobileMark productivity suite.
3. Device-initiated power management (DIPM) enabled. DIPM slumber and DEVSLP ena-
bled.
4. Active maximum power is an average power measurement performed using Iometer
with 128KB sequential write transfers.
Table 7: Maximum Ratings
Parameter/Condition Symbol Min Max Unit Notes
Voltage input, 2.5-inch V5 4.5 5.5 V –
Voltage input, M.2 3V3 3.14 3.46 V –
Operating temperature T
C
0 70 °C 1
Non-operating temperature – –40 85 °C –
Rate of temperature change – – 20 °C/hour –
Relative humidity (non-condensing) – 5 95 % –
Note:
1. Operating temperature is best measured by reading the SSD's on-board temperature
sensor, which is recorded in SMART attribute 194 (0xC2).
Table 8: Shock and Vibration
Parameter/Condition Specification
Non-operating shock 1500G/0.5ms
Non-operating vibration 5–800Hz @ 3.10G
1100 2.5-Inch and M.2 NAND Flash SSD
Electrical Characteristics
CCMTD-1725822587-10292
1100_ssd.pdf - Rev. C 12/16 EN
8
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2015 Micron Technology, Inc. All rights reserved.