EVB90614 user manual
On the CD you find the Software for the USB evaluation board. Double click and follow
the instructions to install.
The user license needs to be agreed 2 times for different parts of the used software.
Use the typical installation.
The SW will be installed in a file "Melexis".You can start program from
Start/Programs/Melexis/MLX Configurator.
If module is set in PWM mode-push-pull ,yes it cannot go back to SMBus.
If module is set to PWM mode-open drain,module can go back to SMBus mode.
The basic panel looks thus now::
When USBEVB is attached to a usb port a LED on pcb board shines BLUE.
When start program the SW automatically recognizes the module type(single or dual
zone) ,SMBus address and power supply(3 or 5 Volts) and turns on it and the LED shines
GREEN.
If no module presents the LED shines RED, power supply is turn off in this case.When
you insert a module, push the button Refresh (The program checks the module version
and when recognizes it, power supply is turned on) .
The button Promt opens a window from which
you can manually send commands to
USBEVB.The commands supported by USBEVB
you can find in attachments (PromtComands.xls).