STANDARD
SIZE
A
5962-90633
COLUMBUS, OHIO 43218-3990
REVISION LEVEL
B
SHEET
3
DSCC FORM 2234
APR 97
1.3 Absolute maximum ratings. 1/
Supply voltage (V
S
) ....................................................................... ±18 V dc
Input voltage .................................................................................. ±18 V dc
Differential input voltage ................................................................ +V
S
and –V
S
Output short circuit duration ........................................................... Indefinite
Storage temperature range ............................................................ -65°C to +150°C
Lead temperature (soldering, 10 seconds) .................................... +300°C
Internal power dissipation (P
D
) ...................................................... 500 mW
Thermal resistance, junction-to-case (θ
JC
) .................................... See MIL-STD-1835
Thermal resistance, junction-to-ambient (θ
JA
) ............................... 110°C/W
1.4 Recommended operating conditions.
Supply voltage (V
S
) ....................................................................... ±15 V dc
Ambient operating temperature range (T
A
) ................................... -55°C to +125°C
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
DEPARTMENT OF DEFENSE SPECIFICATION
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-883 - Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard Electronic Component Case Outlines.
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-HDBK-103 - List of Standard Microcircuit Drawings.
MIL-HDBK-780 - Standard Microcircuit Drawings.
(Copies of these documents are available online at http://quicksearch.dla.mil/
or from the Standardization Document Order
Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text
of this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
________
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.