311
Amphenol Corporation Tel: 800-627-7100 www.amphenolrf.com
Assembly
Assembly Instructions-C37 Amphenol
®
TNC
Step 1A
Step 1B
Step 2
Step 3
Step 4
Step 1A For all cables listed, except Plenum 62.
Slide clamp nut over cable. Strip cable to dimension
shown. Cut braid and dielectric square. Do not nick
center conductor.
Step 1B For Plenum 62 (IBM 4885584). Same as step 1A, and
then slit jacket back .125"(3.2 mm) in four places 90°
apart as shown in illustration.
Step 2 Slide contact assembly under braid and jacket until braid
butts as shown. Use caution that braid slides over contact
assembly and not inside of it. Be sure center conductor
is visible through side hole of contact. Crimp contact to
conductor using Amphenol CTL-1 crimp tool; or by using
die set 227-1221-13 cavity B in tool frame 227-944.
Step 3 Insert into connector body.
Step 4 Tighten clamp nut to a torque of 35 lbf-in.
clamp contact plug body TNC
nut assembly
Amphenol Cable
Center Contact Affixment
Number RG-/U Hex Size
Die Set for CTL Series
Tool 227-944 Tool Number
31-5061 59, 59A, 62, 62A .068(1.7)
227-1221-13
CTL-1
Cavity B
