PAXCDS30 Datasheet PAXCDS30, PAXCDS10 | P1-P2

DESCRIPTION

This bulletin serves as a guide for the installation of PAX Setpoint cards. The

setpoint cards are available as dual relay, quad relay, quad sinking transistor,

quad sourcing transistor/SSR drive, or dual triac/dual SSR drive outputs.

INSTALLING A PAXCDS OPTION CARD

Caution: The option and main circuit boards contain static

sensitive components. Before handling the cards, discharge static

charges from your body by touching a grounded bare metal

object. Ideally, handle the circuit boards at a static controlled

clean workstation. Dirt, oil or other contaminants that may

contact the circuit boards can adversely affect circuit operation.

Warning: Exposed line voltage may be present on the circuit

boards when power is applied. Remove all power to the unit AND

load circuits before accessing the unit.

1. When handling the main circuit board, hold it by the rear cover. When

handling the output card, hold it by the terminal block.

2. Remove the main assembly from the rear of the case by squeezing both finger

holds on the rear cover and pulling the assembly out of the case. Or use a

small screwdriver to depress the side latches and pull the main assembly out

of the case. Do not remove the rear cover from the main circuit board.

3. Install the output card by locating the PAXCDS output card slot location on

the main circuit board. Align the option card terminal block with slot # 3

terminal block position of the rear cover. Align the PAXCDS connector with

the main circuit board option card connector and then press to fully engage

the connectors. Verify that the tab on the option card rests in the alignment

slot on the display board.

4. If installing a PAXCDS60 option card; a knock-out on the top of the PAX case

will need to be removed to allow the PAXCDS60 top terminal block to be

inserted later. Locate the shaped knock-out, positioned at the Setpoint

Option, Option Slot 3, location. When looking at the case from the back with

knock-outs on top, it is the shaped knock-out on the right. Carefully

remove the knock-out, being careful not to remove any additional knock-outs.

Trim any knock-out tabs (gates) that remain on the case. Complete Step 5 and

then plug the PAXCDS60 top terminal into the PAXCDS60.

5. Slide the assembly back into the case. Be sure the rear cover latches fully

engage in the case.

6. Apply the option card label to the bottom side of the unit. Do not cover the

vents on the top surface of the unit. The surface of the case must be clean

for the label to adhere properly. Apply the label to the area designated by the

large case label.

MODEL PAXCDS -SETPOINT OUTPUT OPTION CARDS

Finger

Tab

Finger

Tab

Slot #

Alignment

Slot 3

Main

Circuit

Board

123

PAXCDS

Option Card

Connector

Rear

Cover

PAXCDS Rear

Terminal Block

Position

SETPOINT

OUTPUT

CARD

LABEL

SERIAL

OUTPUT

CARD

LABEL

MAIN LABEL

(bottom of unit)

ANALOG

OUTPUT OR

REAL-TIME

CLOCK CARD

LABEL

QUAD SINKING

- 04 SNK.

PAXCDS30

- COMMON

- 03 SNK.

- 01 SNK.

- 02 SNK.

- COMMON

DUAL RELAY

PAXCDS10

QUAD RELAY

PAXCDS20

QUAD SOURCING/SSR DRIVE

- 04 SRC.

PAXCDS40

- COMMON

- 03 SRC.

- 01 SRC.

- 02 SRC.

- EXTERNAL SUPPLY

DUAL TRIAC/DUAL SSR DRIVE

TRIAC 2

- 04 SSR

TRIAC 1

COMM 1/2

PAXCDS50

- COMM 3/4

- 03 SSR

RLY1

RLY2

RLY1

COMM

RLY2

RLY3

COMM

RLY4

PAXCDS TERMINAL CONNECTIONS

TOP VIEW

Bulletin No. PAXCDS-J

Drawing No. LP0400

Released 01/15

Tel +1 (717) 767-6511

Fax +1 (717) 764-0839

www.redlion.net

N.O.

N.C.

COMM.

N.O.

N.C.

COMM.

N.O.

N.C.

COMM.

N.O.

N.C.

COMM.

RELAY 4 RELAY 3

123456

QUAD FORM C RELAY

PAXCDS60

RELAY 1RELAY 2

Top

Terminal

SPECIFICATIONS

Setpoint Output Cards: Six types of field installable cards

Response Time: 200 msec. max. to within 99% of final readout value

(digital filter and internal zero correction disabled) 700 msec. max.

(digital filter disabled, internal zero correction enabled)

PAXH only: 1 sec. max. to within 99% of final readout value (digital

filter disabled)

PAXT only: 200 msec. typ.; 700 msec max. (digital filter disabled)

PAXH Isolation For All Four Cards:

Isolation To Sensor Common: 1400 Vrms for 1 min.

Isolation To User Input Common: 500 Vrms for 1 min.

Dual Relay Card: PAXCDS10

Type: Two FORM-C relays

Isolation To Sensor & User Input Commons: 2000 Vrms for 1 min.

Contact Rating:

One Relay Energized: 5 amps @ 120/240 VAC or 28 VDC (resistive

load).

Total Current With Both Relays Energized not to exceed 5 amps

Life expectancy: 100 K cycles min. at full load rating. External RC

snubber extends relay life for operation with inductive loads

Quad Form A Relay Card: PAXCDS20

Type: Four FORM-A relays

Isolation To Sensor & User Input Commons: 2300 Vrms for 1 min.

Contact Rating:

One Relay Energized: 3 amps @ 250 VAC or 30 VDC (resistive load).

Total Current With All Four Relays Energized not to exceed 4 amps

Life Expectancy: 100 K cycles min. at full load rating. External RC

snubber extends relay life for operation with inductive loads

Quad Sinking Open Collector Card: PAXCDS30

Type: Four isolated sinking NPN transistors.

Isolation To Sensor & User Input Commons: 500 Vrms for 1 min.

Not Isolated from all other commons.

Rating: 100 mA max @ V

SAT

= 0.7 V max. V

MAX

= 30 V

Quad Sourcing Open Collector/SSR Drive Card: PAXCDS40

Type: Four isolated sourcing PNP transistors.

Isolation To Sensor & User Input Commons: 500 Vrms for 1 min.

Not Isolated from all other commons.

Rating:

Internal supply: 18/24 VDC (unit dependent) ± 10%, 30 mA max. total

all four outputs

External supply: 30 VDC max., 100 mA max each output

Dual Triac/Dual SSR Drive Card: PAXCDS50

Triac:

Type: Isolated, zero crossing detection

Voltage: 260 VAC max., 20 VAC min.

Max Load Current: 1 Amp @ 25°C

0.75 Amp @ 50°C

Total load current with both triacs ON not to exceed 1.5 Amps

Min Load Current: 5 mA

Off State Leakage Current: 1 mA max @ 60 Hz

Operating Frequency: 20-400 Hz

SSR Drive:

Type: Two isolated sourcing PNP Transistors.

Isolation To Sensor & User Input Commons: 500 Vrms for 1 min.

Not Isolated from all other commons.

Rating:

Output Voltage: 18/24 VDC (unit dependent) ± 10%, 30 mA max.

total both outputs

Quad Form C Relay Card: PAXCDS60

Type: Four FORM-C relays

Isolation To Sensor & User Input Commons: 500 Vrms for 1 min.

Contact Rating:

Rated Load: 3 Amp @ 30 VDC/125 VAC

Total Current With All Four Relays Energized not to exceed 4 amps

Life Expectancy: 100 K cycles min. at full load rating. External RC

snubber extends relay life for operation with inductive loads

Internal Supply

(18/24 V unit dependent)

External Supply

(30 V )

max

Quad Sourcing Open Collector Output Card Supply Select

For Quad Sourcing/SSR Drive Option Card (PAXCDS40), set the jumper for

internal or external supply operation before applying power.

ISOLATION

SOURCE OUT

COMM.

Internal +V

Sourcing Output/SSR Drive Logic Card

(Internal Supply)

ISOLATION

SOURCE OUT (+)

Internal +V

(+30 V MAX.)

EXTERNAL SUPPLY

COMMON (-)

(EXTERNAL SUPPLY AND

SOURCE OUT RETURN)

Sourcing Output Logic Card

(External Supply)

ORDERING INFORMATION

MODEL NO. DESCRIPTION PART NUMBER

PAXCDS

Dual Relay Output Card PAXCDS10

Quad Form A Relay Output Card PAXCDS20

Quad Sinking Open Collector Output Card PAXCDS30

Quad Sourcing Open Collector/SSR Drive

Output Card

PAXCDS40

Dual Triac/Dual SSR Drive Output Card PAXCDS50

Quad Form C Relay Output Card PAXCDS60 *

* This card is not suitable for use in older PAX models. For proper installation, a

case knock-out feature must be present on the top surface of the PAX case. This

feature began to be introduced to the standard PAX units in July of 2014 (2614).

Red Lion Controls

Headquarters

20 Willow Springs Circle

York PA 17406

Tel +1 (717) 767-6511

Fax +1 (717) 764-0839

Red Lion Controls

China

Unit 302, XinAn Plaza

Building 13, No.99 Tianzhou Road

ShangHai, P.R. China 200223

Tel +86 21 6113 3688

Fax +86 21 6113 3683

Red Lion Controls

Europe

Softwareweg 9

NL - 3821 BN Amersfoort

Tel +31 (0) 334 723 225

Fax +31 (0) 334 893 793

Red Lion Controls

India

201-B, 2nd Floor, Park Centra

Opp 32 Mile Stone, Sector-30

Gurgaon-122002 Haryana, India

Tel +91 984 487 0503

P1-P2

PAXCDS30

Mfr. #:

Buy PAXCDS30

Manufacturer:

Description:

OPTION CARD OUTPUT PAX QUAD SS

Lifecycle:

New from this manufacturer.

Delivery:

DHL FedEx Ups TNT EMS

Payment:

T/T Paypal Visa MoneyGram Western Union

PAXCDS30

PAXCDS30

Products related to this Datasheet