DC_OK is a collector shorted signal. It is used by an optocoupler in the power supply which indicates the output status of the power supply as exhibited below.
2.Redundant function
(1) UHP-200R is built-in redundant function and can be connected 2 units in parallel .
(2) When in parallel operation the maximum load should not be greater than the rated power of any PSU.
PSU
PSU
LOAD
+V
-V
+V
-V
+V
-V
STATIC CHARACTERISTIC
INPUT VOLTAGE (V) 60Hz
LOAD (%)
90
100
120
180
200240264
100
90
80
70
60
50
40
220
160
140
110
Mechanical Specification
CASE NO.:249B Unit:mm
File Name:UHP-200-SPEC 2018-07-30
UHP-200 series
200W SlimType with PFC Switching Power Supply
Pin No.
1
3
2
Assignment
AC/L
AC/N
AC InputTerminal(TB1) pin NO.Assignment
Terminal
(DEGSON)
DC OutputTerminal(TB2,TB3) pin NO.Assignment
Pin No.
1,2
3,4
Assignment
-V
+V
Terminal
(MW)
Pin No.
1
2
Assignment
DC COM
DC OK +V
DC OK Connector(CN10):JSTB2B-PH-K-S or requivalent
Mating Housing
JSTPHR-2
or requivalent
Terminal
JSTSPH-002T-P0.5S
or requivalent
DG28C-B-03P
TB-HTP-200-40A
Max mounting torque
Max mounting torque
5Kgf-cm8Kgf-cm
12
1
2
3
4
1
2
3
VR
194
188
49.25
3
42
55
3
6.5
7.75
R1.65
26
8.5
17.25
7.62
8.8
8
: Max. CaseTemperature
tc
tc
97
13
File Name:UHP-200-SPEC 2018-07-30
Installation
UHP-200 series
200W SlimType with PFC Switching Power Supply
300
300
M3*4
3
1.Operate with additional aluminum plate
on the bottom.The size of the suggested aluminum plate is shown as below.And for optimizing thermal performance, the aluminum plate must have an even and
smooth surface (or coated with thermal grease), and UHP-200 series must be firmly mounted at the center of the aluminum plate.
In order to meet the“Derating Curve”and the“Static Characteristics”,UHP-200 series must be installed onto an aluminum plate(or the cabinet of the same size)
