L5958 Pin description
Doc ID 17716 Rev 2 7/20
Table 2. Pin description
Pin N# Pin name Function Type
1TAB
2 REG6(1P8P) Output of Reg6 (1.8 V/100 mA) O
3 RES Reset signal for MCU application O
4BU1
Connect to a reserve capacitor. When battery is
removed suddenly, the energy stored in this
capacitor can still supply reg5 and reg6 for some
time.
I/O
5 CRES Connect a capacitor to delay reset signal O
6 REG5(3P3P) Output of Reg5 (3.3 V/100 mA) O
7 GND Power supply ground S
8 SW Output of power switch O
9 EN_SW Enable signal for SW I
10 AUDIO_LOW_IN Hold Audio Low threshold adjustment I
11 VDDCORE Warn signal to 3.3 Vsw or 1. 8Vsw O
12 VIN1 Power supply for Reg1,Reg2,Reg5,Reg6 and SW S
13 CAN_LOW_IN Hold CAN Low threshold adjustment I
14 AUDIO_HIGH_OUT Hold Audio High signal for MCU application O
15 AUDIO_LOW_OUT Hold Audio Low signal for MCU application O
16 REG2(5V) Output of Reg2 O
17 CAN_PRETEMP
Hold can low signal or hold can high signal with
load dump detection or pretemp warning
O
18 REG1(8P5) Output of Reg1 O
19 EN_8P5_5 Enable signal for 5 V and 8.5 V I
20 REG4(1P8sw) Output of Reg4 (1.8 V/350 mA) O
21 IGNOUT Ignition signal output O
22 VIN2 Power supply for Reg3 and Reg4 S
23 IGNIN Ignition signal input I
24 REG3((3P3sw) Output of Reg3 (3.3 V / 250 mA) O
25 EN_3P3_1P8
Enable signal for 3.3 Vperm and 1.8 Vperm.
A resistor of 1 k in series to this control pin is
suggested.
I
26 BU2
Connect to a reserve capacitor. When battery is
removed suddenly, the energy stored in this
capacitor can still supply reg3 and reg4 for some
time.
I/O
27 EN_3P3sw_1P8sw Enable signal for 3.3 V and 1.8 V I