www.nxp.com
NXP and the NXP logo are trademarks of NXP B.V. All other product or service names are the property of their respective owners.
© 2017 NXP B.V.
Document Number: GREENCHIPSOLA4FS REV 0
AC-DC Controllers with Integrated PFC
This selection of AC-DC controllers
integrates a power factor corrector (PFC)
controller in a multi-chip IC. Efficient PFC
operation is achieved by implementing
functions for Quasi-Resonant (QR)
operation at high-power levels and valley
skipping at lower power levels.
TEA1713T, TEA1716T, and TEA1916x:
Resonant power supply control IC
with PFC
TEA175x: HV start-up DCM/QR flyback
controller with integrated DCM/QR
PFC controller
AC-DC Controllers with Integrated
Power Switch
This selection of AC-DC controller ICs
features power switches. These highly
integrated devices reduce component
count for more cost-effective application
design while providing advanced control
modes for exceptional efficiency.
TEA172x: HV start-up flyback controller
with integrated MOSFET for 5 W to 11
W applications, f~burst = 430–1750 Hz
Secondary-Side Controllers
Simple, cost-effective power designs. Our
extremely efficient and highly integrated
GreenChip ICs control synchronous
rectification in a compact form factor.
These ‘smart’ solutions mitigate
increasing power demands for designing
more energy-efficient and cost-effective
power supplies.
TEA176x: Synchronous rectification
controller with integrated feedback and
protection
TEA179x: Synchronous rectification
controller suitable for both high-side
and low-side control
TEA1995T: GreenChip synchronous
rectifier controller
USB TYPE-C POWER SOLUTIONS
The USB Type-C connector is changing
the world of charging for the latest
portable electronic platforms and devices.
Its design meets the trend towards
smaller and thinner form factors that
demand higher power density with more
safety features and security.
NXP provides total USB Type-C AC-DC
solutions with higher power density,
security and safety with leading
technologies that enable a shorter time-
to-market, solve application challenges
and adhere to all global power
regulations.
It’s designed with USB PD and
Qualcomm
®
Quick Charge™ to drive a
smarter, more scalable AC-DC solution for
a broader platform of consumer products.
While there are clear advantages of
Type-C connectors, they also pose a
challenge in system design to ensure that
the integrity of downstream circuitry is
maintained. NXP offers a wide portfolio
of smart protection devices that provide
robust protection against any fault events.
PRODUCTS
Primary Controllers
TEA19361T: GreenChip SMPS primary
side control IC with QR/DCM operation
TEA19362T: GreenChip SMPS control
IC
TEA19363T: GreenChip SMPS primary
side control IC with QR/DCM operation
and X-capacitor discharge
TEA1938T: GreenChip SMPS primary
side control IC
Secondary Side (SR) Controller
TEA199x: GreenChip synchronous
rectifier controller
Protocol Controller
TEA19031 (USB PD 2.0 Compliance)
TEA19032 (USB PD 3.0 Compliance)
TEA1905 (QC 4.0+)
Smart Type-C Interface Protection
NX5P3290: USB PD and Type-C
Current-Limited Power Switch
NX20P5090: High Voltage USB PD
Power Switch
MOBILE POWER SOLUTIONS
NXP provides a wide range of products
focusing on mobile power management
systems. From comprehensive input
protection ICs to compact fast charging
charger ICs.
NXP’s mobile power solutions address
the needs for mobile devices, tablets,
laptops and other integrated solutions
that demand outstanding performance in
smaller packages.
PRODUCTS:
PCA9468: High-current fast charger
with 98% efficiency
NX30P6093: OVP with moisture
detection
NX20P0407: Type-C CC/SBU
protection
NX5P3290A: USB PD and Type-C
current-limited power switch
NX20P5090: High-voltage USB PD
power switch
TYPICAL END-TO-END MOBILE CHARGING SYSTEM BLOCK DIAGRAM
CC
SBU
2:1 SC Direct
PCA9468
SYS
28 V
VDM
NXP
®
Adapter
TEA19361
TEA19051B
Opto
TEA1993
QC 4.0+
QC 2.0/3.0/4.0
PD 3.0 PPS
Smartphone
6V
Codec
CC/PD
PHY
AP
PMI
OVP
Vin Impedance Detection
NX30P6093
CC/SBU Protection
NX20P0407
V
BUS
CC1
CC2
SBU1
SBU2
