PS8118B 09/22/04
0)6
,OW/N2ESISTANCE7IDEBAND6IDEO
1UADWITH)NDIVIDUAL#ONTROL
DC Electrical Characteristics (Over the Operating Range, T
A
= –40°C to +85°C, V
CC
= 5V ±5%)
Parameters Description
Test Conditions
(1)
Min.
Typ
(2)
Max. Units
V
ANALOG
Analog Signal Range 0 — 2.0
VV
IH
Input HIGH Voltage Guaranteed Logic HIGH Level 2.0 — —
V
IL
Input LOW Voltage Guaranteed Logic LOW Level –0.5 — 0.8
I
IH
Input HIGH Current V
CC
= Max., V
IN
= V
CC
——±1
AI
IL
Input LOW Current V
CC
= Max., V
IN
= GND — — ±1
I
O
Analog Output Leakage Current 0 S
1
, S
2
or D V
CC
, Switch Off — — ±1
V
IK
Clamp Diode Voltage V
CC
= Min., I
IN
= –18 mA — –0.7 –1.2 V
I
OS
Short Circuit Current
(3)
S
1
, S
2
, D = 0V V
CC
100 — — mA
V
H
Input Hysteresis at Control Pins — 150 — mV
R
ON
Switch On-Resistance
(4)
V
CC
= Min., V
OUT
= 0.975V
R
L
= 75, I
ON
= 13mA
—3 7
V
CC
= MIN., V
OUT
= 1.95V
R
L
= 75, ION = 26mA
—710
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ............................................................. –65°C to +150°C
Ambient Temperature with Power Applied ............................ –40°C to +85°C
Supply Voltage to Ground Potential (Inputs & V
CC
Only)...... –0.5V to +7.0V
Supply Voltage to Ground Potential (Outputs & D/O Only) ... –0.5V to +7.0V
DC Input Voltage ..................................................................... –0.5V to +7.0V
DC Output Current................................................................................ 120mA
Power Dissipation .................................................................................... 0.5W
Note:
Stresses greater than those listed under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is
a stress rating only and functional operation of the device
at these or any other conditions above those indicated in
the operational sections of this specification is not implied.
Exposure to absolute maximum rating conditions for ex-
tended periods may affect reliability.
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V
CC
= 5.0V, T
A
= 25°C ambient and maximum loading.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. Measured by the voltage drop between S
1
, S
2
, and D I/O pins at indicated current through the switch. On-Resistance is determined by the
lower of the voltages on the S
1
, S
2
, and D I/O pins. VOUT is the voltage across R
L
.
