NTS0104_Q100 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2013. All rights reserved.
Product data sheet Rev. 2 — 23 May 2013 6 of 24
NXP Semiconductors
NTS0104-Q100
Dual supply translating transceiver; open drain; auto direction sensing
9. Limiting values
[1] The minimum input and minimum output voltage ratings may be exceeded if the input and output current ratings are observed.
[2] V
CCO
is the supply voltage associated with the output.
[3] For TSSOP14 packages: above 60 C the value of P
tot
derates linearly at 5.5 mW/K.
For DHVQFN14 packages: above 60 C the value of P
tot
derates linearly at 4.5 mW/K.
10. Recommended operating conditions
[1] Hold the A and B sides of an unused I/O pair in the same state, either both at V
CCI
or both at GND.
[2] V
CC(A)
must be less than or equal to V
CC(B)
.
Table 5. Limiting values
In accordance with the Absolute Maximum Rating System (IEC 60134). Voltages are referenced to GND (ground = 0 V).
Symbol Parameter Conditions Min Max Unit
V
CC(A)
supply voltage A 0.5 +6.5 V
V
CC(B)
supply voltage B 0.5 +6.5 V
V
I
input voltage A port and OE input
[1][2]
0.5 +6.5 V
B port
[1][2]
0.5 +6.5 V
V
O
output voltage Active mode
[1][2]
A or B port 0.5 V
CCO
+0.5 V
Power-down or 3-state mode
[1]
A port 0.5 +4.6 V
B port 0.5 +6.5 V
I
IK
input clamping current V
I
<0V 50 - mA
I
OK
output clamping current V
O
<0V 50 - mA
I
O
output current V
O
=0VtoV
CCO
[2]
- 50 mA
I
CC
supply current I
CC(A)
or I
CC(B)
-100mA
I
GND
ground current 100 - mA
T
stg
storage temperature 65 +150 C
P
tot
total power dissipation T
amb
= 40 C to +125 C
[3]
-250mW
Table 6. Recommended operating conditions
[1][2]
Symbol Parameter Conditions Min Max Unit
V
CC(A)
supply voltage A 1.65 3.6 V
V
CC(B)
supply voltage B 2.3 5.5 V
T
amb
ambient temperature 40 +125 C
t/V input transition rise and fall rate A or B port; push-pull driving
V
CC(A)
= 1.65 V to 3.6 V;
V
CC(B)
= 2.3 V to 5.5 V
- 10 ns/V
OE input
V
CC(A)
= 1.65 V to 3.6 V;
V
CC(B)
= 2.3 V to 5.5 V
- 10 ns/V
