Part No: CEM-14R06CT
Description: magnetic buzzer
Phone: 800.275.4899 Fax: 503.612.2381 www.cui.com 20050 SW 112th Ave. Tualatin, OR 97062
Date: 9/12/2006
Unit: mm
Page No: 3 of 5
Mechanical Characteristics
noitidnoC tseTmetI
5 rof nisor ni desremmi era slanimret daeLytilibaredloS
seconds and then immersed in solder bath
of 270 ±5°C for 3 ±1 seconds.
Soldering Heat Resistance Lead terminals are immersed up to 1.5 mm
from the buzzer’s body in solder bath of
260 ±5°C for 3 ±1 seconds.
Terminal Mechanical Strength Apply a force of 9.8 N (1.0 kg) to each terminal
in each axial direction.
gniylppa retfa derusaem eb lliw rezzub ehTnoitarbiV
a vibration amplitude of 1.5mm with 10 to 55 Hz
band of vibration frequency to each of the 3
perpendicular directions for 2 hours.
fo thgieh a morf deppord eb ot si trap ehTtseT porD
75 cm onto a 40 mm thick wooden board 3
times in 3 axis (X, Y, Z) for a total of 9 drops.
Evaluation Standard
90% min. lead terminals should
be wet with solder.
(Except the edge of the terminal.)
No in interference in operation.
No damage or cutting off.
After the test, the part should
meet specifications without any
damage to the appearance and
the SPL should be within
±10 dBA of the initial
measurement.
Environment Test
noitidnoC tseTmetI
rof C°58+ ot detcejbus eb lliw trap ehTtset .pmet hgiH
96 hours.
rof C°04- ot detcejbus eb lliw trap ehTtset .pmet woL
96 hours
enO .selcyc 01 ot detcejbus eb lliw trap ehTkcohs lamrehT
cycle will consist of:
Temp./Humidity cycle The part shall be subjected to 10 cycles. One
cycle will be 24 hours and consist of:
Evaluation Standard
After the test, the part should
meet specifications without any
damage to the appearance or
performance except SPL. After 4
hours at 25°C, the SPL should be
within ±10 dBA of the initial
measurement.
1
Notes: 1. Not recommended for wave soldering
For more information, please visit the product page.
