MAX4634
Fast, Low-Voltage, 4
Ω
,
4-Channel CMOS Analog Multiplexer
_______________________________________________________________________________________ 5
Note 2: The algebraic convention, where the most negative value is a minimum and the most positive value a maximum, is used in
this data sheet.
Note 3: TDFN parts are tested at +25°C and guaranteed by design and correlation over the entire temperature range.
Note 4: ΔR
ON
= R
ON(MAX)
- R
ON(MIN)
.
Note 5: R
ON
and ΔR
ON
matching specifications for TDFN-packaged parts are guaranteed by design.
Note 6: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the
specified analog signal ranges.
Note 7: Guaranteed by design.
Note 8: Off-isolation = 20log
10
(V
COM
/ V
NO
), where V
COM
= output and V
NO
= input to off switch.
Note 9: Between any two switches.
Typical Operating Characteristics
(T
A
= +25°C, unless otherwise noted.)
ELECTRICAL CHARACTERISTICS—Single +3V Supply (continued)
(V+ = +2.7V to +3.3V, V
IH
= 2.0V, V
IL
= 0.4V, T
A
= -40°C to +85°C, unless otherwise noted. Typical values are at V+ = +3V,
T
A
= +25°C.) (Notes 2, 3)
V
COM
= V
NO_
= GND, f = 1MHz, Figure 6
V
NO_
= GND, f = 1MHz, Figure 6
CONDITIONS
pF68C
(ON)
COM On-Capacitance
pF13C
NO_(OFF)
NO_ Off-Capacitance
UNITSMIN TYP MAXSYMBOLPARAMETER
V
COM
= GND, f = 1MHz, Figure 6 pF52C
COM(OFF)
COM Off-Capacitance
V+ = 3.3V, V
IH
= V+, V
IL
= 0 µA0.001 1I+Positive Supply Current
R
L
= 600Ω, f = 20Hz to 20kHz %0.018THDTotal Harmonic Distortion
POWER SUPPLY