This version of the OpenMV M7 Camera has a few new changes for you! Each version of the
OpenMV now comes equipped with a handy protective acrylic case and has also removed the
pre-soldered headers from the board. Instead, you now have the option between normal male
headers (like the ones found on the previous version) or female stackable headers, allowing you
to decide how you use your own OpenMV!
INCLUDES
1x OpenMV M7 Camera
1x Transparent Protective Enclosure
2x 8-pin Male Header
2x 8-pin Female Stackable Header
FEATURES
The STM32F765VI ARM Cortex M7 processor running at 216MHz with 512KB of RAM
and 2MB of flash. All I/O pins output 3.3V and are 5V tolerant.
A full-speed USB (12Mbs) interface to your computer; your OpenMV Cam will appear as
a virtual COM port and a USB flash drive when plugged in.
A μSD card socket capable of 100Mbs reads/writes, which allows your OpenMV Cam to
record video and easily pull machine vision assets off of the μSD card.
A SPI Bus that can run up to 54Mbs, allowing you to easily stream image data off the
system to either the LCD shield, the WiFi shield or another microcontroller.
An I
2
C Bus, CAN Bus and Asynchronous Serial Bus (TX/RX) for interfacing with other
microcontrollers and sensors.
A 12-bit ADC and a 12-bit DAC.
Three I/O pins for servo control.
Interrupts and PWM on all I/O pins (there are 10 I/O pins on the board).
RGB LED and two high-power 850nm IR LEDs.
The OV7725 image sensor is capable of taking 640x480 8-bit grayscale images or
320x240 16-bit RGB565 images at 30 FPS. Your OpenMV Cam comes with a 2.8mm
lens on a standard M12 lens mount. If you want to use more specialized lenses with your
OpenMV Cam, you can easily buy and attach them yourself.
