B310
DF21 Series●0.6mm Pitch Board-to-Fine-Coaxial Cable Connectors
BUsage Recommendations
Note 1: Up to 2 cycles of reflow soldering are possible under the same conditions, provided that
there is a return to normal temperature between the first and second cycle.
Note 2: The temperature profile indicates the board surface temperature at the point of contacts
with the connector terminals (for surface mounted plug assembly).
1. Recommended
Temperature Profile
1. Receptacle Recommended
Manual Soldering Conditions
2.
Recommended Screen Thickness
3. Board Warping
4. Cleaning Conditions
5. Plug Recommended
Soldering Conditions
6. Handling and use
precautions
■
DO NOT mate/un-mate non-terminated plugs with non-mounted receptacles.
This may lead to damage or deformation of the contacts.
■DO NOT touch the exposed contacts of the receptacle with bare fingers. This may leave non-conductive film,
cause corrosion or electrostatic discharge, affecting performance of the connectors or sensitive electronic
components.
■DO NOT apply flux to the contact terminals when hand soldering the receptacle to the board. Wicking of the
flux into the electrical contact areas may lead to connection failures.
Soldering temperature: 340ç ±10°C, soldering time: within 5 sec.
0.15mm
Maximum of 0.03 mm at the connector center section, with both ends of the connector as reference points.
Refer to "Nylon Connector Use Handbook."
260ç ±5ç within 5 sec, 200ç min. within 25 sec.
The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
Nov.1.2016 Copyright 2016 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
Apr.1.2017 Copyright 2017 HIROSE ELECTRIC CO., LTD. All Rights Reserved.