Dual SPDT Analog Switches with
Over-Rail Signal Handling
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS
(V
CC
= +2.7V to +5.5V, T
A
= -40°C to +85°C, unless otherwise noted. Typical values are at V
CC
= +3.0V, T
A
= +25°C, unless other-
wise noted.) (Note 2)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
V
CC
, IN_, CIN_, COM_, NO_,
NC_ to GND (Note 1).........................................-0.3V to +6.0V
COUT_........................................................-0.3V to (V
CC
+ 0.3V)
COUT_ Continuous Current..............................................±20mA
Closed Switch Continuous Current COM_, NO_, NC_
3.5Ω Switch ................................................................±100mA
7Ω Switch .....................................................................±50mA
Peak Current COM_, NO_, NC_ (pulsed at 1ms, 50% duty cycle)
3.5Ω Switch ................................................................±200mA
7Ω Switch ...................................................................±100mA
Peak Current COM_, NO_, NC_ (pulsed at 1ms, 10% duty cycle)
3.5Ω Switch ................................................................±240mA
7Ω Switch ...................................................................±120mA
Continuous Power Dissipation (T
A
= +70°C)
16-Pin TQFN (derate 20.8mW/°C above +70°C) ...........1667mW
Operating Temperature Range ...........................-40°C to +85°C
Junction Temperature......................................................+150°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering, 10s) .................................+300°C
MAX4850/MAX4850H/MAX4852/MAX4852H
Note 1: Signals on IN, NO, NC, or COM below GND are clamped by internal diodes. Limit forward-diode current to maximum
current rating.