LifecyclePhase:
Revision : 1
Expired Period: Forever
Release Date:2014-08-15 14:36:12.0
DATASHEET
SMD C
EAPL3020AA0
10
Copyright © 2010, Everlight Americas Inc. All Rights Reserved. Release Date : 7.Sep.2012. Issue No: 1
americas.com
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350
℃ for 3 seconds within once in less than the
soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful
because the damage of the product is often started at the time of the hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering
iron should be used (as below figure). It should be confirmed beforehand whether the characteristics of the LEDs will or
will not be damaged by repairing.
